Human Touch
Massage Chairs
HT-5320
HT-5320
Replacing the Remote Control
06/01/08
SERVICE LEVEL: 1
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required
Phillips-head screwdriver
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
Removing the Remote Control
- Power off the chair and unplug it.
- Locate the remote control connection to the backrest cover (Fig.1).
- Using a Phillips-head screwdriver, remove the two screws that secure the remote control cord to the backrest cover.
- Pull the remote control cables through the backrest cover, then disconnect the cables.
Installing the New Remote Control
- Connect the new remote control cables to the backrest remote control cables, then push the cables into the backrest.
- Using a Phillips-head screwdriver, replace the two screws that secure the remote control cord to the backrest cover.
- Power on the chair and verify that the new remote control works properly.
Diagram Description (Fig.1): The illustration shows the connection point of the remote control cable to the backrest of the massage chair. A close-up view displays the port with two screw holes labeled 'S1' and 'S2', indicating where the screws are removed and reinserted. The remote control cable is depicted connecting to this port.
