Replacing the Remote Control

To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

Tools Required

Tools Required: Phillips-head screwdriver

NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

Removing the Remote Control

1. Power off the chair and unplug it.
2. Push down on the backrest release lever, then fold the backrest forward onto the chair seat.
   (Illustration shows the backrest folded forward, with the backrest release lever visible.)
3. Locate the remote bracket on the back of the backrest.
   (Illustration shows the back of the backrest with the remote bracket attached by four screws.)
4. Using a Phillips-head screwdriver, remove the four screws that secure the remote bracket to the backrest cover.
5. Pull the remote cables through the backrest cover, then disconnect the connectors.

NOTE: Be sure the backrest remote connector does not fall back into the backrest. If it does, remove the backrest by removing the four backrest screws, using a 4 mm (5/32") Allen key.

Installing the New Remote Control

1. Connect the new remote control connector to the backrest remote control connector, then push the cables into the backrest.
2. Using a Phillips-head screwdriver, replace the four remote bracket screws.
3. Power on the chair and verify that the new remote works.