JABLOTRON JA-110N-DIN PG Bus Power Module
The JA-110N-DIN is a PG bus power module designed for DIN rail mounting, serving as a component within the JABLOTRON system. It features a PG output relay that can be used to control external devices such as lighting or ventilation. The module is intended for installation by trained technicians holding a valid certificate issued by an authorized distributor.
Installation
Electrical devices may only be connected by a trained technician.
Always switch off the power when connecting the module to the system bus.
- Install the module on the DIN rail.
- Connect the bus cable to terminals (1).
- Test the module's operation by pressing the button (4). After powering up, the red LED RELAY (2) lights up.
- Connect the controlled device to the output terminals (5).
Note: If communication is lost, the yellow LED STATUS (3) will signal this condition, and after 60 seconds, the relay will switch to standby.
Figure 1: Product External Part Description
- 1 - Bus terminals
- 2 - Activation LED indicator
- 3 - Fault LED indicator
- 4 - Learn/Manual Trigger Button
- 5 - Relay Terminals
System Registration and Settings
Depending on the control panel type, use the recommended software or application; refer to the control panel manual.
Technical Specifications
| Parameter | Specification |
|---|---|
| Power | |
| Bus power | 12 V (9-15 V) from control panel bus |
| Standby current (relay off) | 5 mA |
| Max current (relay on) | 45 mA |
| Relay Contact Load (Galvanically and safely isolated from the bus) |
|
| Max switching voltage | 250 V AC / 24 V DC |
| Resistive load (cos φ = 1) | max. 16 A |
| Inductive/capacitive load (cos φ = 0.3) | max. 6 A |
| Halogen lighting | max. 1000 W |
| DC current | 384 W |
| Min. switching output DC | 0.5 W |
| Power Dissipation | |
| Module | 1.6 W |
| For cabinet heating purposes | 1.9 W |
| Connected Wires Diameter | max. 2 x 1.5 mm²; 1 x 2.5 mm² |
| Environment | |
| Location | Indoor general use |
| Operating temperature range | -10 °C to +40 °C |
| Operating humidity | 75% RH, non-condensing |
| Dimensions | 18 x 90 x 64 mm (according to EN 60715) |
| Weight | 65 grams |
| Certifying Body | Trezor Test sro (no. 3025) |
| Conforms to | EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
Declaration of Conformity
JABLOTRON a.s. hereby declares that the JA-110N-DIN product complies with the relevant EU harmonisation legislation: directives no: 2014/35/EU, 2014/30/EU, 2011/65/EU, provided it is used as intended. The original declaration of conformity can be found on the website www.jablotron.com in the 'Downloads' section.
Disposal Information
Note: Proper disposal of this product will help save valuable resources and prevent potential negative impacts on human health and the environment, which could result from improper waste handling. Please return the product to the seller or contact local authorities for detailed information on the nearest designated collection point.
For an electronic version of this document (available in other languages) or the JA-100 installer version, scan the provided QR code.
