SALTO inRoomNode Installation Guide
This guide provides instructions for installing the SALTO inRoomNode.
Installation Steps
- Installation: Connect the inRoomNode to the controller.
- Mounting: Press and fix the inRoomNode into place.
- Wiring: Connect the wires according to the diagram (Power, GND, Rx, Tx).
- Initialization: Follow the user manual to initialize the device.
Electrical Characteristics:
| Parameter | Symbol | Min. | Typ. | Max. | Unit |
|---|---|---|---|---|---|
| Power supply | VIN | 3.3 | 12 | V | |
| Tx Output High Voltage | VOH | 2.6 | V | ||
| Tx Output Low Voltage | VOL | 0.7 | V | ||
| Rx Input High Voltage | VIH | 2.3 | 5.25 | V | |
| Rx Input Low Voltage | VIL | 1 | V |
Note: Tx/Rx does not count with under/over voltage protections.
Power Consumption:
- Min: 21mA
- Max: 21mA
SALTO BLUEnet Characteristics:
- Frequency range: 2400-2483.5 MHz
- Standard: Bluetooth Low Energy
- Indoor Radio Range: 10m/15m
- Max output power: 8dBm
Operating Conditions:
- Temperature (Indoor): 0 ÷ 50°C
- Humidity: 0 ÷ 95% (No condensing)
Operational Test and BLUEnet Information
Operational Test: Once the lock and the inRoomNode are installed, check that the lock is active in SALTO's software.
BLUEnet Information: The environment has a direct impact on the BLUEnet range radiation (metal, concrete walls...). The receiver device must be located facing the product antenna. Recommended connectivity distance: 10m - 15m.
Signalling
The inRoomNode uses LEDs to indicate its status:
| LED | LED Mode | Device Status |
|---|---|---|
| POWER LED | Led Off | Not powered |
| POWER LED | Blinking GREEN | Powered from the controller but not good UART link |
| POWER LED | Permanent GREEN | Powered and UART link OK |
| BLUEnet LED | Led Off | Not initialized with Lock-ID |
| BLUEnet LED | Blinking GREEN | Pairing process (Searching lock to pair with) |
| BLUEnet LED | Permanent GREEN | Wireless connection to the lock is OK |
Environmental Considerations
Metal Surroundings: If the device is surrounded by metal surfaces or a metallic environment, radio performance could be seriously affected.
