JABLOTRON JA-110A II Internal Bus Siren with Backup Battery
This document provides installation instructions and technical specifications for the JABLOTRON JA-110A II internal bus siren.
Product Overview
The JA-110A II siren is a component of the JABLOTRON system, used for indoor alarm signaling. Pressing the button on the siren can silence an ongoing alarm, potentially confirming presence or triggering a panic alarm (optional function). The siren occupies one system slot and requires installation by a trained technician with valid certification from an authorized distributor.
[Diagram showing the disassembly of the JA-110A II siren. It illustrates the removal of the siren body from its plastic frame, highlighting the release clips.]
Key Components (Figure 2):
- 1 – LED indicators
- 2 – Buttons
- 3 – Serial number
- 4 – Button clips
- 5 – Piezoelectric siren
- 6 – Bus terminal
- 7 – Tamper sensors
- 8 – Battery connector for BAT-3V2-CR2
Installation
- Remove the siren body (buttons) from the plastic frame by pressing the side of the body (1.) with a screwdriver, as shown in Figure 1.
- Remove the middle part of the frame (3.) by pressing the 4 clips indicated by the arrows (2.).
- Thread the BUS cable through the designated rectangular recess in the plastic base.
- Mount the plastic base in the chosen location using screws. If the siren is battery-powered, place it under the upper part of the plastic base as shown in Figure 1.
- Assemble the plastic frame with the plastic base, which will secure the battery in place.
System Assignment and Settings
Depending on the control panel type, use the recommended software or application. Refer to the control panel's manual for detailed instructions.
Specifications
| Specification | Details |
|---|---|
| Power | 12 V DC (8...15 V) from the control panel bus |
| Optional backup battery | 3.2 V LiFePo4 CR2 0.4 Ah (Battery not included) |
| Standby current consumption for backup | 5 mA |
| Maximum current consumption for cable selection | 120 mA |
| LowBatt status | 2.9 V |
| Type of warning device | Piezoelectric, 100 dB/m (±5 dB/m) |
| Dimensions | 80 x 80 x 35 mm |
| Weight | 92 grams |
| Classification | Security grade 2 / Environmental class II (EN 50131-1) |
| Operating environment | Indoor general use |
| Operating temperature range | -10 °C to +40 °C |
| Operating relative humidity | 75% RH, non-condensing |
| Certifying body | Trezor Test s.r.o. (no. 3025) |
| Conforms to | EN 50131-1, EN 50131-4, EN 50130-4, EN 55032, EN 62368-1, EN 50581 |
| Recommended screw | 2x 3.5 x 40 mm (countersunk head) |
Compliance and Disposal
JABLOTRON a.s. hereby declares that the JA-110A II device complies with the relevant harmonized Union legislation: Directives No: 2014/35/EU, 2014/30/EU, 2011/65/EU. The original declaration of conformity can be found on the JABLOTRON website in the 'Downloads' section.
Disposal Information: Proper disposal of this product helps conserve valuable resources and prevent potential negative impacts on human health and the environment. Please return the product to your seller or contact your local authorities for detailed information on the nearest designated collection point.
QR Code: Scan the attached QR code for the electronic version of this document (available in other languages) or the installer version in JA-100 format.
Translated to PL from EN origin (MLP22004) on 2025-07-28.
