JABLOTRON JA-110B Bus Acoustic Glass Break Detector
Product Overview
The JA-110B is a component of the JABLOTRON system, designed to detect the breaking of glass panes and surfaces in buildings. It operates by reacting to air pressure changes accompanied by the characteristic sound of breaking glass. The detector provides a pulse output, reporting only activation events. Installation requires a trained technician with a valid certificate from an authorized distributor.
Installation
Important: Always switch off the power when connecting the module to the system bus.
- Open the detector cover by pressing the lock (1) with a flat-head screwdriver.
- Remove the PCB - it is secured with a lock (5).
- Insert the bus cable and screw the rear cover part to the wall.
- Replace the PCB and connect the bus cables to the bus terminals (6).
- Adjust the sensitivity of the acoustic sensor using the trimmer (10).
- Close the detector cover.
Figure 1: Product External and Internal Components Description
- 1 - Cover lock
- 2 - Acoustic sensor opening
- 3 - Light guide
- 4 - Acoustic sensor
- 5 - PCB lock
- 6 - Bus terminals
- 7 - Serial number
- 8 - Red LED activation indicator
- 9 - Yellow LED fault indicator
- 10 - Sensitivity adjustment trimmer
- 11 - Tamper contact
System Enrollment
Depending on the control panel type, use the recommended software or application. Refer to the control panel manual for specific instructions.
Technical Specifications
| Parameter | Specification |
|---|---|
| Power Source | From the control panel bus 12 V (9...15 V) |
| Standby Current Consumption | 5 mA |
| Max Current Consumption | 5 mA |
| Recommended Installation Height | 2.5 m above the floor |
| Detection Range | Up to 9 m |
| Minimum Glass Size | 0.6 x 0.6 m |
| Stabilization Time After Power-Up | Max. 60 seconds |
| Dimensions | 40 x 100 x 22 mm |
| Weight | 50 grams |
| Classification | Safety Class II / Environmental Class II (according to EN 50131-1) |
| Environment | Indoor general |
| Operating Temperature Range | -10 °C to +40 °C |
| Average Operational Humidity | 75% RH non-condensing |
| Certification Body | Trezor Test sro (No. 3025), Kiwa Nederland bv |
| Complies With | EN 50131-1, -2-7-1, T 031, EN 50130-4, EN 55032, EN IEC 63000 |
| Recommended Screw | 2x 3.5 x 40 mm (countersunk head) |
Compliance and Disposal
JABLOTRON a.s. hereby declares that the JA-110B complies with the relevant European Union harmonization legislation: Directives No. 2014/30/EU and 2011/65/EU, provided it is used as intended. The original conformity assessment can be found on www.jablotron.com – the Downloads section.
Note: By disposing of this product correctly, you save valuable resources and prevent possible negative effects on human health and the environment that could otherwise arise from incorrect waste disposal. Return the product to the dealer or contact your municipality for more information about the nearest collection point.
CE UKCA
