JABLOTRON JA-110B Acoustic Glass Break Detector for Buses
Product Overview, Installation, and Technical Specifications
Introduction
The JA-110B is a component of the JABLOTRON system, designed to detect the breakage of glass in windows and glass surfaces within buildings. It operates by reacting to changes in air pressure that are accompanied by the characteristic sound of breaking glass. The detector provides a pulse reaction, meaning it only signals an activation event.
Installation of the detector must be performed by a trained technician holding a valid certificate issued by an authorized dealer.
Installation
Warning: When connecting the module to the system bus, always disconnect the power supply. ?
- Open the detector cover by pushing the latch (1) with a screwdriver.
- Remove the printed circuit board; it is secured by a latch (5).
- Insert the bus cable and screw the rear of the cover to the wall.
- Reinsert the PCB and connect the bus cables to the bus terminals (6).
- Adjust the acoustic sensor sensitivity using the trimmer (10).
- Close the detector cover.
Product Diagram
Figure 1 illustrates the external and internal components of the product:
- 1 - Cover latch
- 2 - Acoustic sensor opening
- 3 - Light guide
- 4 - Acoustic sensor
- 5 - Printed circuit board latch
- 6 - Bus terminals
- 7 - Serial number
- 8 - Red LED activation indicator
- 9 - Yellow LED fault indicator
- 10 - Sensitivity adjustment trimmer
- 11 - Tamper contact
System Enrollment
Enrollment into the system depends on the control panel type. Use the recommended software or application, and consult the specific control panel manual for detailed instructions.
Technical Specifications
| Power | 12 V (9...15 V) from the control panel bus |
| Quiescent current consumption | 5 mA |
| Maximum current consumption | 5 mA |
| Recommended installation height | 2.5 m above the floor |
| Detection distance | Up to 9 m |
| Minimum glass size | 0.6 x 0.6 m |
| Stabilization time after power-up | max. 60 s |
| Dimensions | 40 x 100 x 22 mm |
| Weight | 50 g |
| Classification | Security grade II / Environmental class II (according to EN 50131-1) |
| Environment | General indoor |
| Operating temperature range | -10 °C to +40 °C |
| Average operating humidity | 75% RH, non-condensing |
| Certification body | Trezor Test sro (No. 3025), Kiwa Nederland bv |
| Conformity | EN 50131-1, -2-7-1, T 031, EN 50130-4, EN 55032, EN IEC 63000 |
| Recommended screw | Ø 3.5 x 40 mm (countersunk head) |
Declarations and Notes
JABLOTRON a.s. hereby declares that the JA-110B is in compliance with the relevant EU harmonization legislation: Directives No. 2014/30/EU, 2011/65/EU, when used according to its instructions. The original Declaration of Conformity can be found at www.jablotron.com – Downloads section.
Observation: Correct disposal of this product will help save valuable resources and prevent potential negative effects on human health and the environment, which could arise from improper waste handling. Return the product to the reseller or contact the local authority for more information on the nearest designated collection point.
