Heyday™ Open Ear Wireless Sport Earbuds

Getting Started

Welcome to your Heyday™ true wireless earbuds. Let's get you set up.

What's Included:

• Earbuds
• Charging case
• Type-C charging cable

Pairing

Remove your earbuds from the charging case to power on. If the earbuds are not in pairing mode, press and hold the touch control on both earbuds for 3 seconds. The left and right earbuds are connected. The earbud will show a breathing white light. Use Bluetooth settings on your phone to pair with "Heyday Earbud 12".

Charging Earbuds

Charge the earbuds fully prior to first use. Place the earbuds into the charging case to start charging. The earbud charging LED indicator will turn on with a steady white light and turn off when fully charged. Full charge takes approximately 2 hours.

Recharging the Charging Case

When the charging LED indicator on the case flashes red, it indicates low battery. Connect the Type-C charging cable to the charging case and plug the USB-A end into a DC 5V power supply. The case charging LED indicator will flash red while charging and turn solid red when fully charged.

Features

LED Indicators

• Earbud Solid White: Charging complete
• Earbud White Light turns off: Charging complete
• Case Flashing Red Light: Low battery
• Case Solid Red: Charging complete
• Case Flashing White Light: Pairing mode

Audio Cues

• Ascending Tones: Power on
• Descending Tones: Power off
• Single Chime: Pairing

Controls

Left Earbud:

• Play/Pause & Answer/End Call: Press touch control
• Activate Voice Assistant: Double press touch control

Right Earbud:

• Play/Pause & Answer/End Call: Press touch control
• Next Song: Hold touch control for 2 seconds
• Reject Incoming Call: Press touch control
• Power Off: Hold touch control for 5 seconds

Note: The right earbud can be used individually. If earbuds are not connected correctly, turn them on again. If earbuds do not turn on, recharge the battery and try again. If earbuds make no sound, adjust the volume on your connected device. If earbuds make no sound or do not show as available on your connected device, unpair the device and re-pair the desired device.

Troubleshooting and Tips

If your earbuds do not turn on, recharge the battery and try again. If the earbuds do not connect, ensure they are within the Bluetooth connection range. If the earbuds make no sound, adjust the volume on your connected device. If the earbuds make no sound or do not show as available on your connected device, unpair the device and re-pair the desired device.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.