Product Overview
This document provides instructions for the assembly, care, and use of the Buy-Rite Susie Tech Chair, model SY-7903.
Brand: Buy-Rite Salon & Spa Equipment
Model: SY-7903
Contact: 1-800-477-6655 | buyritebeauty.com
List of Parts & Tools
- Cushion [x1]
- Backrest [x1]
- Base [x1]
- M8x30mm Screws (Already Installed) [x4]
- 14mm Wrench [x1]
- Gas Lift and Cover [x1]
Assembly Instructions
Step 1: Attach Backrest to Seat
Turn the seat cushion over. Remove the four screws and washers from the underside using the 14mm wrench [14mm wrench icon]. Position the backrest bracket so its lower mounting holes align with the corresponding threaded holes in the seat cushion. Slide the M8 washers onto each screw, with the flat washer last. Start all four screws loosely to ensure perfect alignment before tightening. Using the 14mm wrench, evenly tighten each screw until snug, being careful not to overtighten.
Step 2: Prepare Gas Lift
Remove the black plastic cap from the gas lift [black plastic cap]. This cap is intended only for shipping and protection during storage.
Step 3: Install Gas Lift into Base
Insert the gas lift into the stool base, ensuring the larger end is pointing downward. Carefully slide the protective cover over the gas lift from the top until it is fully secure.
Step 4: Attach Seat to Gas Lift
Align the top of the gas lift with the center hole on the underside of the seat cushion. Press down firmly to seat the chair.
Product Care
? Brush away excess hair.
? Clean surface with a damp cloth or use a simple soap & water solution.
⚠️ Avoid using corrosive cleaning agents such as bleaches.
? Do not remove upholstery for cleaning.
Product Information
Enjoy your new chair!
After assembly and before use, it is suggested to extend the gas cylinder to its full height and then lower it several times to prime the cylinder.
If you have any questions or concerns, please contact the customer experience team at 912-335-4445.
