Buy Rite Argento Styling Chair - Silver (OD-6819S)

List of Parts & Tools

• Hydraulic Base and Pump Cushion (x1)
• Chair Top (x1)
• Footrest (x1)
• 14mm Wrench (x1)

Assembly Instructions

1. Step 1: Prepare Hydraulic Base

   Remove the pump cushion from the hydraulic base by pulling it away from the pump shaft. Discard the pump cushion after removal.

   [Diagram: Illustration showing the pump cushion being detached from the hydraulic base pump shaft.]

2. Step 2: Raise Hydraulic Shaft

   Pump the hydraulic to raise the shaft to the highest position, preparing to install the chair top on the hydraulic base.

   [Diagram: Illustration of the hydraulic base with its central shaft extended to its maximum height.]

3. Step 3: Attach Chair Top to Base

   To securely attach the chair top to the hydraulic base, align the notch in the seat bracket (located on the bottom of the chair) with the pin on the metal shaft of the hydraulic base. Place the chair top onto the base, ensuring the pin and notch align for proper installation.

   Carefully sit in the chair to ensure the metal shaft is fully secured into the seat bracket. Note: The pin may not slide fully into the top of the seat bracket.

   If the chair top is not stable, repeat steps 1 and 2. Additionally, check the screws on the bottom of the hydraulic base that secure the pump to the base plate to confirm they are securely tightened.

   [Diagram: Illustration showing the alignment of the chair top's seat bracket with the hydraulic base's shaft pin, followed by an illustration of the chair top seated on the base.]

4. Step 4: Install Footrest

   Using the provided 14mm wrench, loosen the two screws in the footrest brackets attached to the bottom of the chair top, located at the front where the footrest connects. Once loosened, slide the metal footrest bars into the footrest brackets and tighten the screws.

   Ensure all screws are tight and secured prior to use, but be careful not to overtighten.

   [Diagram: Illustration showing the use of a 14mm wrench to tighten screws on the footrest brackets, and the footrest bars being inserted into these brackets.]

Product Care

• Brush away excess hair ?
• Clean surface with damp cloth or use simple soap & water solution. ??
• Avoid using corrosive cleaning agents such as bleaches. ??
• Do not remove upholstery for cleaning. ??

Product Information

1. Enjoy your new chair!
2. Always keep the hydraulic base in the upright position and never stand solely on the footrest, as it will tip.
3. After assembly and before use, pump the hydraulic to full height and back down several times to prime the hydraulic fluid. This will keep the pump smooth and responsive.
4. Note that short, quick pumping is more effective for adjustments than pressing the lever all the way down each time.
5. If you have any questions or concerns, please contact the Buy Rite customer experience team at 912-335-4445.