Buy-Rite Arctic Styling Chair SY-6262N White Instruction Manual

List of Parts & Tools

• Hydraulic Base and Pump Cushion (x1)
• Chair Top (x1)
• Footrest (x1)
• M8X35mm screws (x2)
• 14mm Wrench (x1)

Assembly Instructions

Step 1: Prepare the Base

Remove the pump cushion from the hydraulic base by pulling it away from the pump shaft. Discard the pump cushion.

Step 2: Raise the Hydraulic Shaft

Pump the hydraulic lever to raise the shaft to its highest position. This prepares the base for the chair top installation.

Step 3: Attach the Chair Top

1. Align the notch in the seat bracket (located on the bottom of the chair) with the pin on the metal shaft of the hydraulic base.
2. Place the chair top onto the base, ensuring the pin and notch align for proper installation.
3. Sit in the chair to ensure the metal shaft is fully secured into the seat bracket. Note: The pin may not slide fully into the top of the seat bracket.
4. If the chair top is not stable, repeat steps 1 and 2. Check the screws on the bottom of the hydraulic base that secure the pump to the base plate to ensure they are tightened.

Step 4: Attach the Footrest

1. Using the provided 14mm wrench, remove the two screws located at the front of the chair top where the footrest will connect.
2. Attach the metal footrest to the chair top using these same screws.
3. Ensure all screws are tight and secured before use, but be careful not to overtighten.

Product Care

• Cleaning: Brush away excess hair. Clean surfaces with a damp cloth or a simple soap and water solution. Avoid using corrosive cleaning agents such as bleaches. Do not remove upholstery for cleaning.

Product Information

1. Enjoy your new chair!
2. Always keep the hydraulic base in the upright position. Never stand solely on the footrest, as it may cause the chair to tip.
3. After assembly and before use, pump the hydraulic to full height and back down several times to prime the hydraulic fluid. This will keep the pump smooth and responsive.
4. Short, quick pumping actions are more effective for adjustments than pressing the lever all the way down each time.
5. For any questions or concerns, please contact the Buy-Rite customer experience team at 912-335-4445.