Safety Precautions
This product is for indoor use only.
IMPORTANT: Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Parts Overview
- Main lamp body with three adjustable arms.
- Ceiling mounting canopy.
- Three lamp head assemblies, each consisting of a threaded component and a retaining ring.
- Wiring connectors.
Assembly Steps
Step 1: Adjust Lamp Arms
The main lamp body has three adjustable arms. The diagram indicates that these arms can be positioned as desired. Ensure the arms are securely set after adjustment.
Step 2: Prepare Lamp Heads
For each of the three arms, insert the threaded component into the end of the arm. Then, place a retaining ring over the threaded component to secure the lamp head assembly.
Step 3: Prepare Wiring
Prepare the electrical wires by stripping approximately 20 mm (3/4 inch) of insulation from their ends.
Step 4: Connect Wiring
Connect the main power supply wires to the lamp's internal wiring using the provided push-in connectors. Insert the Live wire (L) into the 'L' terminal and the Neutral wire (N) into the 'N' terminal. Ensure a secure connection. Close the connector housing.
Step 5: Mount to Ceiling
Feed the connected wires through the ceiling canopy. Attach the lamp body to the canopy, ensuring it is securely supported by the hanging loop (20-35 mm / 3/4" - 1 3/8" length).
Step 6: Install Bulbs
Screw the light bulbs (not included) into the lamp sockets.
