FELSISK Pendant Lamp
Important Safety Information
Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
CAUTION! Do not overtighten.
Package Contents
The following components are included:
- 1x Canopy (bowl-shaped cover)
- 2x Cable holder clips
- 1x Ceiling mounting bracket with screw
Assembly Instructions
Step 1
Insert the electrical cable through the opening at the top of the canopy.
Step 2
Attach one of the cable holder clips to the electrical cable.
Step 3
Connect the ceiling mounting bracket to the electrical cable assembly. This involves a spring-loaded mechanism.
Step 4
Secure the electrical cable within the channels of the mounting bracket.
Step 5
Further secure the electrical cable in the mounting bracket.
Step 6
Prepare the electrical cable by carefully stripping the ends of the wires. The canopy is now ready to be attached.
Step 7
Connect the wires to the connector block. Insert the Line wire (L) into the 'L' terminal and the Neutral wire (N) into the 'N' terminal.
Step 8
Secure the connector block. Ensure the wires are properly seated. A "click" sound indicates it is locked.
Step 9
Detailed view of wire insertion into the connector block, showing the 'L' and 'N' terminals.
Step 10
Final securing of the connector block.
Step 11
Attach the canopy to the ceiling mounting bracket. Adjust the electrical cable length by sliding it through the canopy and securing it with the clips. Ensure the cable hangs 20-40 mm (3/4" - 1 1/2") below the canopy.
Step 12
Screw in the light bulb.
