Maiden Home Bank Console Table Assembly Instructions
Assembly requires 1-2 people.
Included Components & Hardware
- Tabletop (1)
- Legs With Metal Bracket Attachment (2)
- Joint Screws (16)
- Allen Key (1)
Diagram: A visual representation of the tabletop, two legs with attached metal brackets, an Allen key, and sixteen joint screws.
Assembly Steps
-
Lay the tabletop flat on a protected surface with the underside facing up.
Diagram: The tabletop is shown upside down on a flat surface.
-
Rest the legs with the attached metal brackets into the corresponding center insets on the underside of the tabletop.
Diagram: Two legs are positioned into the designated areas on the upside-down tabletop.
-
Secure the legs by placing the screws into the pre-drilled holes of the metal brackets, then screwing them into place with the Allen key. Take care not to strip the screws.
Diagram: Screws are being inserted into the metal brackets on the legs and tightened with the Allen key.
-
Take a moment to confirm that the hardware is secured tightly at all connection points.
Diagram: A close-up showing the secured connection points of the legs to the tabletop.
-
With the help of another person, carefully flip the table over.
Diagram: Two people are shown carefully turning the assembled table upright.
