The Ria Coffee Table

Components & Hardware

• Allen Wrench (1): A hexagonal L-shaped tool for tightening screws.
• Corner Brackets (10): Small metal plates with pre-drilled holes, used to connect legs to the undermount.
• Flat Head Screws (40): Small screws with flat heads, used for securing brackets and legs.
• Pan Head Screws (6): Small screws with rounded heads, used for attaching the tabletop.
• Tabletop (1): The main, flat surface of the coffee table.
• Undermount (1): A structural base component that connects the legs to the tabletop.
• Legs (4): The four vertical supports for the coffee table.

Note: Assembly requires three people. ?

Assembly Steps

Step 1: Separate Undermount from Tabletop

Keeping the tabletop in its crate, place it on the floor with the underside facing up. Use the Allen wrench to remove the pan head screws securing the undermount to the tabletop. Carefully separate the undermount from the tabletop.

Step 2: Attach Brackets to Legs

Place the corner brackets over the pre-drilled holes on each leg. Insert two flat head screws into each corner bracket. Use the Allen wrench to tighten the screws and secure the brackets to the legs.

Step 3: Attach Legs to Undermount

Rest the undermount on the ground with its underside facing up. Place the legs on top of the undermount, ensuring the holes on the corner brackets align with the corresponding holes on the undermount. Insert two flat head screws into each corner bracket and tighten them using the Allen wrench.

Step 4: Confirm Hardware Security

Take a moment to confirm that all hardware is securely tightened at all connection points. ✔️

Step 5: Flip the Base

With the help of another person, carefully flip the assembled undermount and legs over.

Step 6: Attach Tabletop

With three people holding the tabletop vertically, lift it and place it on top of the undermount. Align the pre-drilled holes on the tabletop's underside with the pre-drilled holes on the undermount. From underneath the table, insert the pan head screws into the aligned holes and tighten them using the Allen wrench to secure the tabletop. Important: Do not use power tools to tighten the screws.

Step 7: Final Check

Take a moment to confirm that all hardware is securely tightened at all connection points. ✔️