The Bank Round Dining Table

Included Components & Hardware

• Tabletop (1)
• Base With Metal Bracket Attachment (1)
• Joint Screws (8)
• Allen Key (1)

Notes

Assembly requires 1-2 people.

Assembly Steps

1. Step 1

   Lay the tabletop flat on a protected surface with the underside facing up.

   Diagram: A round tabletop is shown from above, with the underside facing up, indicating a central square recess.

2. Step 2

   Rest the base with the attached metal brackets into the corresponding center insets.

   Diagram: The base, a conical structure with flared sides and a square base, is shown being placed into the central recess of the upside-down tabletop. Metal brackets on the base align with indentations on the tabletop.

3. Step 3

   Secure the base by placing the screws into the pre-drilled holes of the metal brackets, then screwing them into place with the Allen key. Take care not to strip the screws.

   Diagram: Close-up view showing screws being inserted through the metal brackets on the base and into the tabletop. An Allen key is depicted engaging with a screw head.

4. Step 4

   Take a moment to confirm that the hardware is secured tightly at all connection points.

   Diagram: The base is shown attached to the tabletop, with arrows indicating the points where screws have secured the brackets.

5. Step 5

   With the help of another person, carefully flip the table over.

   Diagram: Two figures are shown carefully lifting and flipping the assembled dining table upright.