The Rene Side Table
Assembly Instructions
Included Components & Hardware
- Base (1)
- Tabletop (1)
Tools Needed
Level
Notes
Assembly requires 2 people.
Assembly Steps
-
Step 1
Locate the nut underneath the base and remove it, as this nut is used only for transit protection. Once the nut is removed, install the leveling glides, adjusting them as needed to ensure the base sits evenly on the floor.
Diagram illustrating the removal of the transit nut and installation of leveling glides on the base. -
Step 2
Looking at the top of the base, check to ensure the bumper quantity and placement match the illustration at right.
Illustration showing the correct placement and quantity of bumpers on the top of the base. -
Step 3
Lay the paper template on top of the glass. With two people holding the tabletop above the base, carefully rotate it as needed to match the intended orientation illustrated at right.
Diagram showing the tabletop being aligned with the base using a paper template. Dimensions: Width: 18", Depth: 18", Height: 17.5", Tabletop Thickness: [not specified], Base Diameter: 12.5", Base Height: 16.5". -
Step 4
Once the tabletop is in the proper position, carefully lower it onto the base and remove the template. The tabletop should be securely positioned atop the base.
Diagram showing the tabletop securely placed on the base.
