TEEHO Door Lock Installation Instructions

Product Overview

This document provides installation instructions for the TEEHO TE001 Keyless Entry Door Lock.

Illustration of the TEEHO TE001 lock exterior and interior components.

Parts List

Ensure all parts are present before beginning installation. Refer to the following for identification:

• Exterior Assembly (a)
• Interior Assembly (i)
• Latch (b)
• Strike (c)
• Reinforcement plate (d)
• Mounting Plate (e)
• Latch/Strike Screws (f)
• Reinforcement Screws (g)
• Mounting Screws (h)
• Interior Screws (k)
• Battery Cover (m)
• Drive-In Collar
• Backup Key
• Reset Tool

Diagram showing all individual parts labeled with letters.

1. Prepare the Door and Check Dimensions

Verify door and door jamb preparation:

• Door Thickness: 1-3/8" to 2" (35mm to 50mm)
• Backset: 2-3/8" or 2-3/4" (60mm or 70mm)
• Hole in Door (for exterior assembly): 2-1/8" (54mm)
• Hole in Door (for latch): 1" (25mm)

Ensure the slotted hole for the latch is centered in the door hole.

Diagrams illustrating the required door measurements for thickness, backset, and hole sizes.

2. Choose Faceplate

Select the appropriate faceplate for your door's edge preparation.

Illustration showing two types of faceplates and how they fit into the door edge.

3. Install Latch and Deadbolt

Important: Keep the latch in the unlocked position before installation.

Rotate and pull the latch to extend it. Ensure the latch is parallel to the door edge.

Diagram showing how to extend the latch and install it into the door edge, with a checkmark for correct orientation and an 'X' for incorrect.

4. Install Exterior Assembly

Route the cable below the latch. Insert the exterior assembly into the door hole.

Diagram showing the exterior assembly being inserted into the door and the cable being routed.

5. Install Interior Assembly

Important: Do not load batteries until the lock is completely installed.

Route the cable through the hole in the mounting plate. Secure the mounting plate with the supplied screws.

Note the horizontal orientation of the torque blade. Rotate the thumb turn to the vertical position and insert the torque blade into the inside escutcheon.

Secure the interior assembly with the supplied screws.

Diagrams illustrating the routing of the cable, securing the mounting plate, and installing the interior assembly with attention to the torque blade orientation.

6. Detect Left/Right Hand Door Installation

Important: This step is required and crucial for the lock after installation!

While the door is open and unlocked, load 3 AA batteries into the interior assembly. Use new, non-rechargeable alkaline batteries for best results.

Press and hold the reset button on the interior assembly using the reset tool. Keep holding until you hear a long "BEEP".

Load the last battery and keep holding the reset button for 3 seconds until you hear a long "BEEP". The latch bolt will extend to learn the door orientation.

Test the lock by rotating the thumb turn to ensure the bolt extends and retracts smoothly.

Diagrams showing the battery installation process and the use of the reset tool. Visual cues for successful learning of door orientation.