INSTALLATION INSTRUCTION
Vector - LED Track Kit (Single)
Model: MO-495
Safety Precautions
WARNING
IMPORTANT: NEVER attempt any work without shutting off the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
- Before proceeding, go to the main fuse box or circuit breaker. Place the main power switch in the "OFF" position and unscrew the fuse(s) or switch "OFF" the circuit breaker switch(es) that control the power to the fixture or room.
- Place the wall switch in the "OFF" position.
CAUTION
- All parts must be used as indicated in these instructions. Do not substitute, omit, or use worn out or broken parts. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.
- When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
Hardware Included
| Identifier | Description | Quantity |
|---|---|---|
| A1 | P3 Wire Connector | 3 pcs |
| B1 | Junction Box Screw | 2 pcs + 1 Extra |
| C1 | Mounting Screw | 2 pcs + 1 Extra |
| D1 | P1 Wire Connector | 2 pcs |
Preparation
- Shut off the power at the circuit breaker and remove the existing fixture, including its mounting hardware.
- Carefully unpack your new fixture and lay out all parts on a clear area. Be careful not to lose any small parts necessary for installation.
Installation Steps
The following steps detail the installation process, referencing components shown in Figure 1 (Ground wire, Driver, Mounting plate, Canopy, Junction Box, Power input wire, Wire Connectors A1/D1, Junction Box Screws B1, Mounting Screws C1, Output Wire) and wiring connections in Figure 2.
Step 1: Prepare Fixture
Remove mounting plate screw (C1) from the fixture and remove wire connectors (D1).
Step 2: Connect Wires (Refer to Figure 2)
Connect the driver input wires to the supply wires using wire connectors (A1). Ensure all wire connectors (A1) are securely fastened. If your outlet box has a green or bare copper ground wire, connect the fixture's ground wire to it. Otherwise, connect the fixture's ground wire directly to the mounting plate using the provided green screw. After connecting wires, carefully tuck them inside the junction box. Note: The driver must be recessed within the junction box.
Wire Connection Details (Figure 2):
- Fixture Wires (Black or Smooth) connect to House Wires (Black - Hot)
- Fixture Wires (White or Ribbed) connect to House Wires (White - Neutral)
- Fixture Wires (Bare wire - Ground) connect to House Wires (Green or Bare Copper - Ground)
Step 3: Mount Fixture Plate
Secure the mounting plate to the junction box using the junction box screws (B1). Ensure the side of the mounting plate marked "GND" faces outward.
Step 4: Connect Output Wires
Connect the driver output wires to the fixture wires and secure with wire connectors (D1).
Step 5: Attach Canopy
Place the mounting canopy over the mounting plate and secure it using the mounting plate screws (C1).
