INSTALLATION INSTRUCTION

Safety Warnings and Cautions

WARNING

⚠️ IMPORTANT: NEVER attempt any work without shutting off the electricity.

• Read all instructions before installing.
• System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
• Go to the main fuse box, or circuit breaker. Place the main power switch in the "OFF" position and unscrew the fuse(s) or switch "OFF" the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
• Place the wall switch in the "OFF" position.

CAUTION

❗ All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this fixture.

❗ When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

Hardware Included

The following hardware components are included for installation:

Preparation

• Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
• Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

Mounting the Fixture (Refer to Fig. 1)

Fig. 1 Description: This diagram shows the assembly of the LED track kit components including the junction box, power input wire, driver, mounting plate, canopy, output wire, and various connectors and screws labeled A1, B1, C1, D1.

Step 1: Initial Fixture Preparation

Remove mounting plate screw (C1) from fixture, remove wire connectors (D1).

Step 2: Secure Mounting Plate

Secure the mounting plate to the junction box using the junction box screws (B1). The side of the mounting plate marked "GND" must face out.

Step 3: Mount Canopy

Place the mounting canopy over the mounting plate and secure with the mounting plate screws (C1).

Connecting the Wires (Refer to Fig. 2)

Fig. 2 Description: This diagram illustrates the wire connections between the fixture and the house wiring. It shows three sets of connections: Fixture Wires (Black or Smooth) connect to House Wires (Black - Hot) using Wire Connector A1. Fixture Wires (White or Ribbed) connect to House Wires (White - Neutral) using Wire Connector A1. Fixture Wires (Bare wire - Ground) connect to House Wires (Green or Bare Copper - Ground) using the green screw provided or a Wire Connector.

Step 1: Connect Driver Input Wires

Connect the driver input wires to supply wires as shown in Fig. 2, using wire connectors (A1). Make sure that all wire connectors (A1) are secured.

If your outlet box has a green or bare copper ground wire, connect the fixture's ground wire. Otherwise, connect the fixture's ground wire directly to the mounting plate using the green screw provided.

After wires are connected, tuck them carefully inside the junction box.

? Note: Requires driver to be recessed within the junction box.

Step 2: Connect Driver Output Wires

Connect the driver output wires to the fixture wires, secure with wire connectors (D1).

Company Information

WAC Lighting

Website: www.waclighting.com

Phone: (800) 526.2588

Fax: (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive, Port Washington, NY 11050

Phone: (516) 515.5000

Fax: (516) 515.5050

Western Distribution Center

1750 Archibald Ave, Ontario, CA 91761

Phone: (800) 526.2588

Fax: (800) 526.2585