Exterminator II - LED Monopoint

Safety Instructions

IMPORTANT:

• NEVER attempt any work without shutting off the electricity.
• Read all instructions before installing.
• System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
• Go to the main fuse box, or circuit breaker. Place the main power switch in the "OFF" position and unscrew the fuse(s) or switch "OFF" the circuit breaker switch(es) that control the power to the fixture or room that you are working on.
• Place the wall switch in the "OFF" position.

CAUTION

• All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken.
• Failure to follow this instruction could invalidate the UL/CUL listing of this fixture.

(French safety warnings have been translated and incorporated into the English instructions.)

Electrical Data

Installing Lamp (Fig. 1)

Diagram Description (Fig. 1): The diagram illustrates the mounting process. It shows the Base Plate, which attaches to the surface using mounting screws. The Canopy attaches to the Base Plate via Canopy Mounting Screws. A Ground Wire connection is also indicated. The luminaire body can be rotated 360 degrees and adjusted vertically up to ±90 degrees from the vertical position.

1. Loosen the three canopy screws, twist and separate the canopy cover from the base plate. (Keep screws on base plate)
2. Remove a knock out from the base plate.
3. Attach the base plate to the surface using slotted holes for mounting screws (supplied).
4. Connect fixture wires to AC power wire, with wire nuts (supplied).
5. Connect ground wire to the green wire from fixture.
6. Mount the canopy to the base plate by twisting key holes over three screws in base plate.
7. Tighten screws to secure canopy.
8. After the light is on, rotate the luminaire body horizontally or vertically to aim properly.

Accessories (Fig. 2)

Diagram Description (Fig. 2): This diagram displays optional accessories for the luminaire. Components shown are Snoot, Spacer, Lens, Front frame, and Cross louver. The accessories are attached to the front of the fixture using clips or screws located around the front frame.

1. Use a screw-driver to loosen the two screws at the back of the fixture body.
2. Take out the front frame, then change the lens.
3. To install cross louver or snoot, use the clips around the front frame to fasten them directly.

Aligning the Reflector (Fig. 3)

Before putting the accessory assembly back to the fixture, make sure to align the reflector properly as shown in Fig. 3.

Diagram Description (Fig. 3): The diagram shows how to align the reflector within the LED Holder. It specifies that two legs of the reflector need to be inserted into corresponding holes on the LED holder for proper installation.