First Time Setup: Bluetooth Pairing
Turn on the Bluetooth in your device settings.
[Visual: Phone screen displaying Bluetooth settings with the toggle switched ON.]
Press and hold the button for 10 seconds. Release.
The indicator light near the foam ear pad will blink red and blue to indicate pairing mode.
[Visual: Headphones illustration showing the multi-function button being pressed. Callout points to the ear cup area showing a red and blue blinking light.]
Select "JLab Rewind" in your device settings to connect.
The indicator light will slow blink blue when Bluetooth is paired.
[Visual: Phone screen displaying available Bluetooth devices, with "JLab Rewind" selected. Callout shows the headphone indicator light now slow blinking blue.]
Pairing New / Additional Devices:
Turn OFF Bluetooth on your previously paired device and turn ON Bluetooth on the new device. Repeat the FIRST TIME SETUP process for new devices.
Notes:
- Bluetooth is a wireless radio technology, which means it is sensitive to objects between the headphone and the connected device.
- The headphone is designed to be used within 33 feet (10 meters) of a connected device, with no major objects in between (walls, etc.).
- Once successfully connected, the headphone will memorize your device and automatically pair when turned on in the future.
- Only one device may be connected at a time. To pair a different device, first unpair the current one through its Bluetooth settings.
- If for any reason Bluetooth connection is lost, manually reconnect your Bluetooth device.
Charging
Note: Headphones will not turn on while charging. Allow about 3 hours to fully charge.
Connect the Rewind Headphone to a computer or USB 5V output device with the provided charging cable.
A red light will indicate charging, and a blue light will indicate a full charge.
[Visual: Diagram showing the Rewind Wireless Headphones connected via a USB cable to a power source such as a computer USB port or wall adapter. Indicator lights are shown: Red for "CHARGING" and Blue for "FULLY CHARGED".]
Button Functions
Bluetooth Pairing: (Follow First Time Setup instructions)
Power On: Press & hold for 2 seconds.
Power Off: Press & hold for 4 seconds. (Slow blinking blue light indicates power is on).
Play / Pause / Answer / Hang Up: 1 click.
Activate Siri (iOS) or "OK Google" (Android): 2 clicks.
Track Forward: Press & hold for 2 seconds.
Equalizer Modes
Toggle EQ Change: 3 clicks. (Rewind will cycle through 3 EQ settings)
- JLab Signature (One Beep): JLab C3™ signature sound with amplified vocals and bass.
- Balanced (Two Beeps): Even sound with no additional sound enhancements.
- Bass Boost (Three Beeps): Amplified bass and sub-bass.
Cautions
- Avoid getting moisture or liquids on the headphone cups.
- Avoid extreme heat, cold, and humidity.
- Avoid dropping or crushing headphones, stressing the cable by rapid pulling or extreme force, or bending the cable at a sharp angle.
- Wax may build up in headphone cups, lowering the sound quality. Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
- If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
- If you experience regular discomfort while using this product, discontinue use and consult your physician.
- We recommend you treat your headphones as you would a nice pair of sunglasses and keep them in a safe location when not in use.
Resources
Shop products | Product alerts | Burn-in your headphones
JLab Audio + Burn-in Tool
Visit JLab Audio: jlabaudio.com
