JLab Rewind Wireless Headphones

JLab Rewind Wireless Headphones

Before First Use: Bluetooth Connection

1. Activate Bluetooth in your device settings.
2. Press and hold the power button for more than 10 seconds. Release. The LED near the foam earpiece will flash red and blue to indicate pairing mode. [red/blue flashing LED]
3. In your device settings, select "JLab Rewind" to establish a connection. The LED will flash blue slowly once the Bluetooth connection is established. [slow blue flashing LED]

Diagrams show phone Bluetooth settings with 'JLab Rewind' selected.

Connecting New / Additional Devices

To connect a new device, first DEACTIVATE Bluetooth on your previously paired device and then ACTIVATE it on the new device. Repeat the "Before First Use" steps.

Notes:

• Bluetooth is a wireless radio technology sensitive to objects between the headphones and the device. The headphones are designed for use within 10 meters (approx. 33 feet) without major obstructions like walls.
• Once successfully connected, the headphones will remember your device and automatically connect when turned on.
• Only one device can be connected at a time. To connect another device, first disconnect the current one via Bluetooth settings.
• If the Bluetooth connection is interrupted, reconnect your Bluetooth device manually.

Voice and Sound Notifications

• Power On: Chime ?
• Connected to Bluetooth: Two beeps ?
• Battery Low: "Low Battery" voice prompt (less than 20%) ?
• Power Off: Chime ?

Charging

Note: The headphones cannot be turned on while charging. A full charge takes approximately 3 hours.

Connect the Rewind headphones using the included charging cable to a computer or a USB 5V output device. A red LED indicates charging [red LED], and a blue LED indicates fully charged [blue LED].

Diagram shows headphones connected to a USB cable for charging.

Button Functions

Bluetooth Connection

• Power On: Press and hold the power button for 2 seconds.
• Power Off: Press and hold the power button for 4 seconds (the slowly flashing blue LED indicates the headphones are on).

Playback & Calls

• Play / Pause / Answer Call / Hang Up: Click once (1x). ▶️ / ?

Voice Assistant

• Activate Siri (iOS) or "OK Google" (Android): Click twice (2x). ?️

Track Navigation

• Next Track: Press and hold the power button for 2 seconds. ⏭️

Equalizer Modes

Change EQ: Click three times (3x). The Rewind headphones feature 3 EQ settings that cycle through.

• JLab Signature (One beep): JLab C3™ Signature Sound with enhanced vocals and bass.
• Balanced (Two beeps): Even sound without additional bass boost.
• Bass Boost (Three beeps): Enhanced bass and sub-bass.

Caution

• Avoid getting moisture or liquids into the earcups.
• Avoid extreme heat, cold, and humidity.
• Do not drop or crush the headphones. Avoid straining the cable with sudden pulls or extreme force, or bending the cable at sharp angles.
• Wax may accumulate in the earcups, affecting sound quality. Carefully remove wax with a cotton swab or other small tool to improve sound quality.
• If you experience discomfort or pain, try lowering the volume or temporarily discontinuing use.
• If you regularly experience discomfort while using this product, discontinue use and consult your doctor.
• We recommend treating your headphones like a pair of stylish sunglasses and storing them in a safe place when not in use.

More Information

Explore more: Buy Products | Product Announcements | Headphone Burn-in

Learn more about JLab Audio and the Burn-in Tool.

[Download on the App Store]

[Get it on Google Play]

Visit us online: intl.jlabaudio.com