LEXON Flip Travel Alarm Clock LR150
User Manual
Introduction
The LEXON Flip Travel Alarm Clock LR150 is a compact and stylish companion designed for travelers and everyday use. Its innovative flip design protects the display and controls when not in use, while allowing it to stand upright for easy viewing when open.
Key Features
- Compact and portable design
- Unique flip-open functionality for easy operation and protection
- Clear digital time display
- Adjustable alarm with snooze function
- Simple button controls
- Battery-powered for convenience
Flip Mechanism: The clock features a unique flip design. When closed, the display is hidden and buttons are protected. When opened, the clock stands securely on its base, ready for use.
Getting Started
Battery Installation
This clock requires 2x AAA batteries (not included). To install batteries:
- Locate the battery compartment on the back of the clock.
- Open the compartment cover.
- Insert 2x AAA batteries, ensuring correct polarity (+ and -) as indicated inside the compartment.
- Close the battery compartment cover securely.
Note: Remove batteries if the clock will not be used for an extended period.
Operating Instructions
Setting the Time
To set the current time:
- Press and hold the TIME button.
- Use the HOUR button to advance the hour and the MINUTE button to advance the minute.
- Press the TIME button again to confirm and exit time setting mode.
Setting the Alarm
To set your desired alarm time:
- Press and hold the ALARM button.
- Use the HOUR button to set the alarm hour and the MINUTE button to set the alarm minute.
- Press the ALARM button again to confirm the alarm time.
Activating and Deactivating the Alarm
Locate the ALARM ON/OFF switch on the side or back of the clock.
- Slide the switch to the ON position (often indicated by a bell icon [?] or 'ON'). The alarm is now active.
- Slide the switch to the OFF position (often indicated by 'OFF' or no icon). The alarm is deactivated.
Using the Snooze Function
When the alarm sounds:
- Press the SNOOZE button located on the top of the clock.
- The alarm will be silenced temporarily and will sound again after approximately 9 minutes.
Stopping the Alarm
To stop the alarm completely:
- Press any button other than SNOOZE, or
- Close the clock by flipping it shut.
Care and Maintenance
- Clean the clock with a soft, dry cloth. Do not use liquids or abrasive cleaning agents.
- Replace batteries promptly when the display becomes dim or the clock stops functioning correctly.
Troubleshooting
The clock is not working.
- Ensure batteries are correctly installed with proper polarity.
- Replace batteries with fresh ones.
The alarm is not sounding.
- Verify that the ALARM ON/OFF switch is in the ON position.
- Check that the alarm time has been set correctly.