Shark Rotator Pet Plus Quick Start Guide
Getting Started
Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
What's Inside
- A: Vacuum Pod
- B: Handle & Hose
- C: Wand
- D: Hose Clip
- E: Duster Crevice Tool
- F: Upholstery Tool
- G: Dusting Brush
Emptying the Dust Cup
Empty the dust cup after each use.
The process involves detaching the dust cup, opening the filter door, and emptying the contents. Ensure the cup is clean.
Assembly
Follow these steps to assemble your vacuum. Ensure all parts are firmly CLICKED into place for proper operation.
- Connect the Handle & Hose (B) to the Vacuum Pod (A).
- Attach the Wand (C) to the Handle & Hose (B).
- Connect the Hose Clip (D) to the Wand (C).
- The Duster Crevice Tool (E), Upholstery Tool (F), and Dusting Brush (G) are accessories that attach to the wand or handle.
Visual description: The assembly diagram shows the main vacuum pod (A) at the base, with the handle and hose unit (B) connecting to it. The wand (C) extends from the handle, and the hose clip (D) attaches to the wand. Accessories E, F, and G are shown as separate tools that can be connected to the wand or handle. Indicators labeled "[click]" show where parts securely connect.
Maintenance
Regular maintenance ensures strong suction.
Filter Maintenance
To access the foam and felt filters, remove the dust cup. Press down on the top of the filter door, tilt it, and lift it out. To remove the HEPA filter, press the tab at its top and pull it away from the vacuum base.
To reinstall, insert the HEPA filter into the unit and replace the filter door.
Wash filters every 3 months. Rinse filters with water only and allow them to air-dry completely. Tap loose dirt from foam filters as needed between washes.
Brushroll Access
To access the brushroll area for cleaning, use a coin to turn the locks. Lift the cover open to clear any debris from the intake.
Floor Cleaning
Your vacuum offers two cleaning modes for different floor types:
- Hard Floor: Press the switch to position 'I' for hard floor surfaces.
- Carpet: Press the switch to position 'II' for low and high pile carpet cleaning.
Suction Control: Adjust suction based on your floor type. Use 'MIN' to reduce suction and increase maneuverability on carpets. Use 'MAX' to increase suction on bare floors.
To engage the brushroll, step on the floor nozzle and tilt the handle back.
Above-Floor Cleaning
For cleaning areas above the floor:
- To clean above-floor areas, remove the handle from the wand. For greater reach, remove the wand from the pod.
- Attach the desired cleaning accessory to the handle or wand.
