Shark Rocket ULTRA-LIGHT VACUUM

Diagram showing assembly steps with labels A-G and click indicators.

Step 1: Connect the Wand (C) to the Motorized Floor Nozzle (B). You will hear a click. [click-symbol]

Step 2: Attach the Handheld Vacuum (A) to the Wand (C). You will hear a click. [click-symbol]

Diagram showing handheld vacuum attached to the storage hook on the wand, with cord wrapped.

Handheld Vacuum Storage Hook

Handheld Vacuum Catch

Empty the dust cup every time debris reaches the MAX fill line.

WARNING: Hand wash filters only with water to prevent damage from cleaning chemicals. Allow ALL filters to air-dry completely before replacing them in the vacuum to prevent liquid from being drawn into electric parts.

Diagram showing dust cup being emptied and filter maintenance.

Brushroll Maintenance

To access the brushroll, open the three locks on the bottom of the floor nozzle and lift off the cover. Remove any string, carpet fibers, or hair that may be wrapped around the brushroll. Loosen debris by cutting across the groove on the brushroll with a pair of scissors.

Diagram showing how to open the floor nozzle cover and clean the brushroll.

1. Plug In Vacuum

Then place your foot gently on the floor nozzle and tilt the handle back.

Diagram illustrating plugging in the vacuum and tilting the handle.

2. Choose Setting

The Rocket® Ultra-Light Upright has a 2-speed power slider switch on the handle. Slide the power switch to the appropriate floor setting and start cleaning.

• Setting I: Gentle on bare floors and small area rugs. The brushroll spins slowly to clean bare floors and small area rugs.
• Setting II: Deep-cleans carpets by removing embedded dirt. The brushroll spins faster to pick up debris below the surface of your carpets.

NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpet) please use Setting II, carpet mode.

Diagrams illustrating Setting I and Setting II with descriptions.

1. Disconnect Wand

While holding the vacuum upright, push the Nozzle Release button and pull the wand up to disconnect it from the floor nozzle. [wand-release-button-symbol]

OR

Press the Wand Release button on the top of the wand to disconnect it from the handheld vacuum. [wand-release-button-symbol]

Diagrams showing how to release the wand from the floor nozzle and from the handheld vacuum.

Handheld Vacuum Storage Hook

Floor Nozzle Release

Wand Release

2. Attach Cleaning Accessory

Attach desired cleaning accessory.

NOTE: Use Setting I for all above-floor accessories.

Diagram showing various cleaning accessories being attached to the handheld vacuum or wand.