Shark Rotator Pet Plus Quick Start Guide
Please be sure to read the enclosed Shark Owner's Guide prior to using your unit.
What's Inside
- A Vacuum Pod
- B Handle & Hose
- C Wand
- D Hose Clip
- E 5.5" Crevice Tool
- F Pet Power Brush
Assembly
Follow these steps to assemble your vacuum. Ensure all parts are firmly clicked into place for proper operation.
Connect the Wand (C) to the Vacuum Pod (A) with an audible click [click].
Attach the Handle & Hose (B) to the Wand (C) with an audible click [click].
Secure the Hose Clip (D) to the wand.
The Crevice Tool (E) and Pet Power Brush (F) are accessories that can be attached later.
Emptying the Dust Cup
Empty the dust cup after each use.
To empty, press the release button on the dust cup and lift it away from the vacuum base. Empty the contents into a trash receptacle.
Maintenance
Filters
Remove the dust cup to access the foam and felt filters. Press down on the top of the filter door, tilt the door, and lift it out.
To remove the HEPA filter, press the tab at the top and pull it away from the vacuum base.
To reinstall, insert the HEPA filter and replace the filter door.
Wash filters every 3 months to maintain strong suction. Rinse filters with water only and allow them to air-dry completely. Tap loose dirt from foam filters as needed between washes.
Brushroll Access
To access the brushroll, use a coin to turn the locks [unlock-symbol]. Lift the cover open [open-cover-symbol] to clear the debris intake [clear-intake-symbol].
2 Ways to Clean
Floor Cleaning
Suction Control
Adjust your suction depending on your floor type:
- MIN: To reduce suction and increase maneuverability on carpets.
- MAX: To increase suction on bare floors.
Hard Floor: Press the switch to position 'I' for hard floor surfaces.
Carpet: Press the switch to position 'II' for low and high pile carpet cleaning.
To engage the brushroll, step on the floor nozzle and tilt the handle back.
Above-Floor Cleaning
To clean above-floor areas:
Remove the handle from the wand. For more reach, remove the wand from the pod.
Attach your desired cleaning accessory to the handle or wand.
