This document has been machine-translated from the original English version. In case of any ambiguities or discrepancies, please refer to the original document. If you encounter any errors or have further questions, please contact technical support.
The product is a component of the JABLOTRON system. It is used for indoor alarm indication. Pressing the siren button can acknowledge the alarm indication (= confirming the presence of a person in the building). Siren installation must be performed by a qualified specialist with a valid certificate issued by an authorized distributor.
Installation
Always connect the bus when the system power is completely off.
- Remove the siren casing from the plastic frame by pressing the side of the casing (1.) with a screwdriver, as shown in Figure 1.
- Remove the middle frame part (3.) by pressing the 4 retainers indicated by arrows (2.).
- Thread the bus cable through the special rectangular opening in the plastic base.
- Attach the plastic base to the chosen location using screws.
- Reassemble the plastic frame with the plastic base onto the lower part.
- Connect the bus cable to the terminals (6) as shown in Figure 2, and insert the casing back into the plastic frame.
Attention: the tamper contacts (7) must be located above the magnets in the plastic base.
Figure 1: Siren removal before installation. Shows a square siren unit with labels pointing to: 1. Electronics latches.
Figure 2: Internal view of the siren. Shows the rear of the siren unit with terminals labeled: 1. Electronics latches; 2. Internal buttons; 3. Serial number; 4. Casing pins; 5. Piezoelectric siren; 6. Bus terminals; 7. Tamper contact.
Registration and Settings
Depending on the control panel type, use the recommended software or application; refer to the control panel manual.
Technical Specifications
| Parameter | Value |
|---|---|
| Power Source | 12 V DC bus (9...15 V) |
| Standby Current Consumption | 5 mA |
| Maximum Current Consumption | 30 mA |
| Siren | Piezoelectric, 85 dB/m |
| Notification Device Type | For indoor use, Type X |
| Dimensions | 80 x 80 x 28 mm |
| Acoustic Characteristics | 80 dB/1 m |
| Classification | Security grade 2 / Environmental class II (according to EN 50131-1) |
| Environment | Indoor general use |
| Weight | 70 g |
| Operating Temperature Range | -10 °C to +40 °C |
| Relative Humidity | 75% RH, non-condensing |
| Certification Body | Trezor Test s.r.o. (no. 3025) |
| Conformity | EN 50131-1, -4, EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
| Can be operated in accordance with | ERC REC 70-03 |
| Recommended Screw | 2x Ø 3.5 x 40 mm (countersunk head) |
Compliance and Disposal
JABLOTRON a.s. hereby declares that the JA-110A device complies with the harmonized legislation of the European Union: Directives No. 2014/30/EU, 2014/35/EU, 2011/65/EU when used as intended. The original conformity assessment is available on the JABLOTRON website in the 'Downloads' section.
Note: Proper disposal of this product helps save valuable resources and prevent potential negative impacts on human health and the environment that could result from improper waste handling. Return the product to your dealer or contact your local authorities for more information on the nearest collection point.
To obtain an electronic version of this document (in other languages) or a version for installation in JA-100+, scan the provided QR code.
