JABLOTRON JA-110A Internal Bus Siren
Installation and Technical Specifications
Introduction
This document has been machine-translated from the English original. In case of any ambiguities or doubts, please refer to the original version of the document. If you encounter errors or have further questions, please contact the technical support department (contact details are at the end of this document).
The product is a component of the JABLOTRON system. It is used for alarm signaling inside a building. Pressing the button on the siren can silence the alarm signal (= confirmation of a person's presence in the building). The siren should be installed by a trained technician holding a valid certificate issued by an authorized distributor.
Installation
Always connect the bus when the system power is completely off.
- Remove the siren body (buttons) from the plastic frame by pressing the side of the body (1.) with a screwdriver, as shown in Figure 1.
- Remove the middle part of the frame (3.) by pressing the 4 clips indicated by the arrows (2.).
- Thread the bus cable through the designated rectangular recess in the plastic base.
- Fasten the plastic base in the chosen location using screws.
- Re-attach the plastic frame with the plastic base to the lower part.
- Connect the bus cable to the terminals (6) according to Figure 2 and reinsert the housing back into the plastic frame.
Note: The tamper sensors (7) must be placed over the magnets in the plastic base.
Figure 1: Siren disassembly before mounting. Shows the siren body (1), frame clips (2), and middle frame part (3).
Figure 2: Description of the siren's internal parts. Labels indicate: 1 – electronics latches; 2 – internal buttons; 3 – serial number; 4 – housing terminals; 5 – piezoelectric siren; 6 – bus terminals; 7 – tamper sensor.
System Registration and Settings
Depending on the control panel type, use the recommended software or application; refer to the control panel manual.
Technical Data
| Parameter | Specification |
|---|---|
| Power Supply | Bus 12 V DC (9...15 V) |
| Standby current consumption | 5 mA |
| Max. current consumption | 30 mA |
| Siren | Piezoelectric, 85 dB/m |
| Type of warning device | Indoor, Type X |
| Dimensions | 80 x 80 x 28 mm |
| Acoustic output | 80 dB / 1 m |
| Classification | Security Grade 2 / Environmental Class II. (according to EN 50131-1) |
| Environment | General indoor |
| Weight | 70 grams |
| Operating temperature range | -10 °C to +40 °C |
| Operating humidity | 75% RH, without condensation |
| Certifying unit | Trezor Test sro (no. 3025) |
| Complies with | EN 50131-1, -4, EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
| Can be operated according to | ERC REC 70-03 |
| Recommended screw | 2x Ø 3.5 x 40 mm (pan head) |
Compliance and Disposal
JABLOTRON a.s. hereby declares that the JA-110A device complies with the relevant harmonizing legislation of the European Union: Directives No: 2014/30/EU, 2014/35/EU, 2011/65/EU, provided it is used as intended. The original declaration of conformity can be found on www.jablotron.com – in the 'Downloads' section.
Note: Proper disposal of this product helps conserve valuable resources and prevent potential negative impacts on human health and the environment that could result from improper waste handling. Please return the product to your seller or contact your local authorities for detailed information on the nearest designated collection point.
For an electronic version of this document (available in other languages) or the installer version in JA-100 format, scan the enclosed QR code.
