PrismaSeT LVS03553

Important Notes

Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. Schneider Electric assumes no responsibility for any consequences arising out of the use of this material.

Product Overview

The PrismaSeT LVS03553 is a FuPact ISFT 100N 3P unit designed for mounting within electrical enclosures. This guide details its installation process.

The main unit is shown mounted on a rail system. Associated hardware includes M6 x 16 screws (x4), M6 x 12 screws (x2), and other fasteners.

Assembly Instructions

Follow these steps for proper installation:

Section A: Mounting Rails and Initial Components

This section illustrates the setup of mounting rails and initial components. Two mounting rails are depicted. Key measurements indicated are 50 mm between mounting points and 8 mm for a smaller feature. The hardware specified includes M6 x 16 screws (x4) and M6 x 12 screws (x2).

1. A rail is shown with a specific hole pattern. A horizontal distance of 112.5 mm and a vertical height of 400 mm are indicated for mounting points. The label "m0" likely refers to a mounting hole reference.
2. Illustrations show the initial attachment of components to the rail.
3. Further steps in attaching components to the rail system.
4. Continued illustration of component attachment.
5. Final steps for attaching components to the rail.
6. A component is shown being attached using M6 x 16 screws (x2).

Section B: Frame Structure Assembly

This section details the assembly of a frame structure, with two units required (x2).

1. Illustrations show attaching a component to the frame using clips.
2. The frame is shown being positioned relative to a rail system, indicating its placement within the enclosure.

Section C: Mounting Components with Screws

This section describes mounting components using M6 x 12 screws (x2).

1. An illustration shows a component being attached to the rail system.
2. The process of securing the component is depicted.
3. A close-up view shows an M6 x 12 screw being inserted for fastening.

Section D: Attaching the Main Unit

This section covers the attachment of the main FuPact ISFT 100N 3P unit to the rail system, requiring approximately 24 fasteners (x24).

1. The main unit is shown being positioned for attachment.
2. The unit is depicted being secured with fasteners. A recommended torque of 4.4 N.m is specified for this step.

Section E: Final Installation and Checks

This section outlines the final installation steps and checks.

1. The main unit, identified as LVS03325, is shown being attached to the rail system.
2. A tool is shown being used to secure the unit.
3. Illustrations depict final checks and securing mechanisms.
4. A quarter-turn indicator (1/4) is shown, suggesting a locking mechanism.
5. A safety symbol is displayed, indicating a forbidden action or condition [forbidden symbol].
6. A final check or status indicator is shown.

A diagram shows two possible mounting orientations for a component labeled LVS03325, with a 180-degree rotation capability indicated.

Manufacturer Information

Schneider Electric Industries SAS
35, rue Joseph Monier
92500 Rueil-Malmaison
France
www.se.com

Schneider Electric Limited
Stafford Park 5
Telford, TF3 3BL
United Kingdom
www.se.com/uk

This document has been printed on ecological paper.