PrismaSeT LVS03124 Installation Guide
This guide provides instructions for installing the Schneider Electric PrismaSeT LVS03124 with FuPact ISFT 250.
Product Overview
The PrismaSeT LVS03124 is designed for mounting the FuPact ISFT 250 electrical component. This document outlines the steps for horizontal and fixed installations.
Important Note: Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. Schneider Electric assumes no responsibility for any consequences arising out of the use of this material.
Installation Steps
Section A: Mounting the FuPact ISFT 250
This section details the mounting of the FuPact ISFT 250 unit onto a mounting plate.
Hardware Required:
- M10 x 20 screws (x2)
- M6 x 18 screws (x2)
- M5 x 10 screws (x4)
Assembly Steps:
- Attach the ISFT 250 unit using M10 x 20 screws (20 N.m torque).
- Secure the mounting plate using M6 x 18 screws (4.4 N.m torque).
- Fasten the ISFT 250 to the plate using M5 x 10 screws.
Diagram shows the FuPact ISFT 250 being mounted horizontally onto a green mounting plate, with specific screw types and quantities indicated.
Section B: Alternative Mounting Configurations
This section illustrates different mounting scenarios and component compatibility.
Scenario 1: Standard Horizontal Mounting
Illustrates the installation of ISFT 250 with specific dimensions (X=150, M=6m, H=300) on a 600mm wide panel.
Diagram shows the ISFT 250 being installed within a cabinet, with dimensions and reference numbers LV480824 and 49872.
Scenario 2: Inverted Mounting (180°)
Shows the ISFT 250 installed in an inverted orientation within a 600mm or 850mm cabinet. The diagram indicates a 180-degree rotation.
Diagram shows the ISFT 250 mounted upside down, with reference numbers LVS03328 and LVS03337.
Scenario 3: Mounting with LVS03328
Details the installation of ISFT 250 using the LVS03328 component, with a 180-degree orientation indicated.
Diagram shows the ISFT 250 being installed with the LVS03328, including a rotational indicator.
Technical Specifications and Notes
Dimensions:
- For 600mm width: X = 150, M = 6m, H = 300
- For 850mm width: X = 150, M = 6m, H = 300
Torque Settings:
- M10 x 20: 20 N.m
- M6 x 18: 4.4 N.m
Note on Material: This document has been printed on ecological paper.
