WALI CS303 Installation Manual

WARNING

Before beginning installation, read and understand all instructions and warnings. Contact your local distributor if you have questions. Ensure the supporting surface can safely bear the combined load. For wood studs, anchor screws into the center of the studs. Never exceed maximum load capacity (17.6 lbs / 8 kg). Use assistance for lifting. Tighten screws firmly but do not overtighten. For indoor use only.

What is your wall made of?

• Drywall with wood studs? (Perfect!)

IMPORTANT:

Ensure all parts are present against the component checklist before installation. Contact the franchiser for replacements if any parts are missing or faulty.

Tools Required

• Phillips Head Screw driver
• Electric drill and 8mm masonry bit
• Marking Pen
• Hammer

Parts Included

• Glass holder (x3)
• Wall plate (x2)
• Decorative cover (x4)
• Connect piece (x3)
• Plastic cover (x6)
• ST5.5x50 concrete anchor (x6)
• M5x10 screws (x9)
• 3mm allen key (x1)
• Plastic bush (x3)
• M6x6 screw (x1) (already attached to all plate)

STEP 1A WOOD STUD WALL MOUNTING

Use a stud finder to locate stud edges. Draw a vertical line down each stud's center. Place the wall plate as a template, mark the center of four mounting holes, ensuring they are on the stud centerline. Secure the wall plate with four screws (A), ensuring it is level. Drill four 1/8" (3mm) dia. holes 1.2" (30mm) deep.

STEP 1B SOLID BRICK AND CONCRETE BLOCK MOUNTING

Use the wall plate as a template to mark four hole locations. Pre-drill holes with an 8mm masonry bit to a depth of at least 50mm. Insert concrete anchors (B) into each hole. Attach the wall plate using four screws (A), ensuring it is level.

STEP 2 ASSEMBLING THE GLASS HOLDER

Attach the connect piece (F) to the glass holder (C) using two screws and the reserved space as shown in Figure 2.1. Repeat for other glass holders.

STEP 3 INSTALLING THE GLASS HOLDER

Insert the three glass holders into the wall plate along the rail at the desired height. Tighten screws with a 3mm Allen key (F) to prevent wobbling (Figure 3.1). Insert decorative covers (E) and plastic covers. You can adjust the height by loosening and retightening screws with the 3mm Allen key (F) (Figure 3.2).

STEP 4 INSTALLING THE GLASS SHELF

Gently place the three glass shelves onto the glass holders. Attach shelves using screws and plastic bushes (G, H). Tighten screws with the 3mm Allen key (F) initially, then center the shelves and securely tighten the screws (Figure 4.1).

STEP 5 CABLE MANAGEMENT

Place the DVD player gently on the mounted glass shelves. Pull out a cable clip. Insert the cable into an opening of the clip. Insert the clip into the main pole. Guide the other end of the cable from another opening and push the clip to the end of the main pole (Figure 5.1).

Maintenance

• After mounting, check that the DVD bracket is sufficiently secured and safe to use.
• Check screw tightness every two months.
• For installation doubts, contact support@walielectric.com.