WALI Wooden Floating Wall Mount Shelf
Model: CS201N
Important Safety Information and Installation Guidelines
Please read the entire instruction manual before starting installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- This product is designed to be installed on wood stud walls, solid concrete walls or brick walls.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement.
MAINTENANCE: Check that the bracket is secure and safe to use at regular intervals (at least every three months).
Parts List
Verify all parts are present before installation:
- A1 (x1) - Shelf
- A2 (x1) - Shelf
- B1 (x4) - Wall Screws
- B2 (x2) - Bracket Screws
- B3 (x2) - Bracket Screws
- B4 (x2) - Shelf Screws
- B5 (x4) - Wall Anchors
- B6 (x4) - Wall Anchors
- B7 (x1) - Bracket
Installation Steps
Step 1: Prepare Wall Mounting
1a: For wood stud walls, locate studs and drill pilot holes. For concrete or brick walls, drill holes using an appropriate drill bit (e.g., 8mm / 5/16 inch) and insert wall anchors (B5/B6). Ensure the mounting holes are at least 50mm (2 inches) from the edge of the wall material. The bracket (B7) requires two mounting points.
1b: Attach the bracket (B7) to the wall using wall screws (B1) and wall anchors (B5/B6) if needed. Ensure the bracket is level and securely fastened.
Step 2: Attach Shelf to Bracket
Align the shelf (A1/A2) with the bracket (B7). The diagram shows the shelf resting on the bracket arms.
Step 3: Secure Shelf
Insert bracket screws (B2) through the pre-drilled holes on the underside of the bracket arms into the shelf. Then, insert shelf screws (B4) through the pre-drilled holes on the side of the bracket arms into the shelf. Do not overtighten.
Step 4: Final Check
Ensure the shelf is securely attached and level.
