Important Safety Information
General Warnings
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. WALI cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or inappropriate use.
⚠️ TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER.
TO HELP PREVENT TIPOVER:
- NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
- USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Installation Steps
Step 1: Assemble the Base and Pole
Attach the lower pole (②) to the base plate (①) using parts ⑥ and ⑧. Insert the upper pole (③) into the lower pole. Secure connections using screws F, L, N, and washers C, B.
Step 2: Attach Shelf and Upper Bracket
Slide the shelf (⑤) onto the upper pole (③) and secure it with part ⑦ using screws G, H, K, M, E, D, C, B, A, and N.
Step 3: Measure TV VESA Holes and Select Screws
Measure the width and height of your TV's VESA mounting holes. Standard VESA patterns range from 75x75mm up to 600x400mm. If your TV's width exceeds 600mm or height exceeds 400mm, STOP installation and contact customer support.
You are provided with M4, M6, and M8 diameter screws (TV1, TV2-3, TV4-6) for attaching the VESA bracket to your TV. Determine the correct screw size that fits your TV's threaded inserts.
Spacers (SP): Use spacers (TV7, TV8, TV9) if your TV has an irregular or obstructed back panel. Diagrams show different spacer configurations for various TV back types.
No Spacers: Use without spacers if your TV has a flat, unobstructed back panel.
WARNING: Please keep these instructions for future reference. Ensure correct screw length and washer usage to avoid damaging the TV.
Step 4: Attach VESA Bracket to TV
Using the appropriate screws (TV1, TV2-3, TV4-6), washers (TV10), and spacers (TV7, TV8, TV9) as determined in Step 3, attach the VESA bracket assembly to the back of your TV. Ensure the bracket is oriented correctly (marked 'Top').
Step 5: Mount TV to Stand and Adjust
Carefully lift the TV with the attached VESA bracket and hook it onto the main stand assembly. Use the provided Allen wrenches (I, J) to secure the TV to the stand, ensuring it is stable. Adjust the tilt angle of the TV to approximately 25° as desired.
