ROLFSTORP LED Lighting

Brand: IKEA

Important Safety Information

⚠️ WARNING: Strangulation Hazard.

Never place the cord within reach of a child in a cot or playpen. Always secure the cord to a wall or cabinet. Check regularly that the cord is securely fastened. Pull the cord to remove any slack between fasteners. Tie up any remaining slack cord between the driver and socket.

⚠️ WARNING: Battery Handling.

Always remove batteries before storing the product.
Do not mix old and new batteries, or batteries of different brands or types.
Only use batteries that are intended for the product.

⚠️ WARNING: Electrical Safety.

Only use a safety transformer with a SELV (Safety Extra Low Voltage) output as a supply for the product.

ⓘ The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.

Product Specifications

Recommended Batteries: LADDA rechargeable batteries
Battery Type: HR6 AA
Voltage: 1.2V
Capacity: 2450 mAh
Quantity Required: 3

Batteries are sold separately.

Installation Guide

Mounting the Fixture

The ROLFSTORP LED lighting fixture can be mounted to a surface using the provided clips.

Step 1: Attach Mounting Clips

Secure the two provided mounting clips to the desired surface (e.g., wall, cabinet). Ensure they are firmly attached.

[Diagram Description: Shows two mounting clips being attached to a surface.]

Step 2: Position and Secure Fixture

Ensure a minimum clearance of 8 cm (3 1/5") from the ceiling or any overhead surface. Align the fixture with the mounted clips and slide it onto them until it clicks securely into place. A close-up view shows a tab or button on the fixture that engages with the clips.

[Diagram Description: Shows the fixture being slid upwards onto the mounted clips. A minimum distance of 8 cm (3 1/5") is indicated. A close-up shows a finger pressing a release tab on the fixture.]

Powering the Fixture

The ROLFSTORP fixture can be powered by batteries or via a USB connection.

Battery Power

Step 3: Install Batteries

Open the battery compartment cover. Insert three (3) AA LR6 1.2V 2450 mAh rechargeable batteries, observing the correct polarity (+ and -). Close the battery compartment cover.

[Diagram Description: Shows opening the battery compartment, inserting three AA batteries with correct polarity, and closing the cover. A warning symbol for batteries (crossed-out battery) is displayed.]

USB Power

Step 4: Connect to Power Source

Connect the provided USB cable to a compatible SELV output safety transformer (sold separately) and plug it into a power outlet. Then, connect the other end of the USB cable to the fixture's power port.

[Diagram Description: Shows connecting a USB cable to a power adapter, then plugging the adapter into a wall socket. Another diagram shows connecting the USB cable to the fixture's port.]

Operating the Light

Step 5: Control the Light

Use the switch on the fixture to control the light. A short press (approximately 0.5 seconds) turns the light on or off. A longer press (approximately 1.5 seconds) may adjust brightness or cycle through modes.

[Diagram Description: Shows the ON/OFF switch on the fixture and how to operate it.]

Battery Life Estimates

With fully charged LADDA 2450 mAh batteries, the estimated battery life is:

Approximately 2 hours of continuous use.
Approximately 4 hours of continuous use.
Approximately 12 hours of continuous use.

[Diagram Description: Illustrates the fixture emitting light with battery symbols indicating usage times of 2 hours, 4 hours, and 12 hours, corresponding to the battery capacity.]

General Warnings & Disposal

This product contains small parts and is not intended for use by children without adult supervision.

Battery Disposal: Do not dispose of batteries in household waste. Check local regulations for proper disposal methods.

	ROLFSTORP LED Lighting - IKEA Installation and Safety Guide Comprehensive guide for installing and safely using the IKEA ROLFSTORP LED lighting, including battery and power adapter instructions, and important safety warnings.
	ROLFSTORP LED Lighting: Assembly and Safety Guide Detailed assembly instructions and safety guidelines for the IKEA ROLFSTORP LED lighting fixture. Learn how to install, power, operate, and maintain your ROLFSTORP light.
	ROLFSTORP LED Light - IKEA User Manual Detailed user manual and installation guide for the IKEA ROLFSTORP LED light, including safety instructions, operation, and battery information.
	ROLFSTORP LED Light - IKEA Assembly Instructions and User Guide Comprehensive assembly instructions and user guide for the IKEA ROLFSTORP LED light. Learn how to install, operate, and maintain your ROLFSTORP light, including battery usage, charging, and dimming features.
	ROLFSTORP LED Lighting - IKEA Assembly and User Guide Comprehensive assembly instructions and user guide for the IKEA ROLFSTORP LED lighting, including safety information, battery usage, installation steps, and operation details.
	IKEA NÖDMAST LED Lamp - Assembly and User Guide Comprehensive guide for the IKEA NÖDMAST LED lamp, covering assembly, battery installation, safety precautions, and operation. Learn how to set up and use your NÖDMAST lamp for indoor lighting.
	IKEA FLOALT LED Light Panel Installation Guide Comprehensive installation guide for the IKEA FLOALT LED light panel, part of the TRÅDFRI smart lighting system. Includes safety warnings, step-by-step assembly instructions, system compatibility, mounting dimensions, and disposal information.
	ROLFSTORP LED Luminaire - IKEA Installation and Safety Guide Detailed instructions for installing and using the IKEA ROLFSTORP LED luminaire. Includes safety warnings, battery information, and mounting guidance. Learn how to safely set up and operate your ROLFSTORP light.