ROLFSTORP

Important Safety Information

General Warnings

This is an electrically operated product. Not recommended for children under 3 years of age. As with all electric products, precautions should be observed during handling and use to prevent electric shock.

Storage

Always remove the batteries before storing the product.

Light Source

The light source of this luminaire is not replaceable. When the light source reaches its end of life, the entire luminaire must be replaced.

Battery Usage

Only use batteries that are intended for the product. Do not mix old and new batteries, different brands, or types of batteries.

Batteries are sold separately. IKEA recommends LADDA rechargeable batteries (2450 mAh, HR6 AA, 1.2V). 3 pieces are required.

Assembly and Support

Diagram 1: Shows a person holding a screwdriver, with an 'X' symbol indicating caution or incorrect usage.

Diagram 2: Shows a person looking confused at a product component, then making a phone call to IKEA, suggesting to contact IKEA for assistance if needed.

Installation Steps

Step 1: Prepare Mounting Brackets

Diagram shows two circular mounting brackets being attached to the back of the ROLFSTORP light bar, with arrows indicating insertion.

Step 2: Mount to Wall

Diagram shows the light bar being lifted towards a wall, with two mounting points (indicated by 'X' marks) on the wall where screws would be inserted. Arrows show the upward motion for placement.

Step 3: Secure Light Bar

Diagram shows the light bar being slid into place against the wall. An inset shows a close-up of a finger pushing the light bar against a mounting point, with an arrow indicating a sliding or clicking motion to secure it. 'X' marks indicate screw points.

Powering the Light

Diagram 1: Shows a USB power adapter (5V DC Min 0.6A) being plugged into a wall socket.

Diagram 2: Shows a laptop connected via USB (5V DC Min 0.6A), implying it can be powered by a USB port.

Diagram 3: Shows the ROLFSTORP light bar with its power port, and a USB cable connecting it to a power source (represented by the adapter in the inset).

Operating the Light

Diagram shows the ROLFSTORP light bar. A finger is shown pressing a button on the light bar, with an arrow indicating the action.

Switch Operation

The light has an 'OFF' and 'ON' switch. Slide the switch to 'ON' or 'OFF'.

Adjusting Brightness

The brightness can be adjusted via the touch-sensitive button on the light bar.

Short presses (approx. 0.5 seconds) cycle through different brightness levels.

A longer press (approx. 1.5 seconds) may set the light to its dimmest setting or turn it off, depending on the sequence.

Charging

The light can be charged via USB. A low battery indicator is shown.

Diagram shows the ROLFSTORP light bar connected to a power source via USB. An inset shows a finger pressing the power button. Another inset shows the battery indicator changing from low charge to full charge.