FALCON RIDGE

Safety and Preparation

⚠️ Caution: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. ?

Read these instructions thoroughly before opening and installing the enclosure. Installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro; if conditions prevent installing in warmer weather, store the adhesive Velcro at room temperature prior to installation.

Installation Instructions

1. Carefully open the carton and remove the rolled-up Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab. Check over the parts included in the carton with the parts list shown below:

   Velcro Hook Strips:

   Quantity	Length
   4 each	6" long
   2 each	9" long
   4 each	10" long
   2 each	12" long
   2 each	15" long
   2 each	18" long
   2 each	20" long
   4 each	22" long
   2 each	24" long
   2 each	33" long

   If any parts are damaged or missing, please contact customer service at (606) 845-7439.

2. Begin by cleaning the roll cage from front to back along the outside edges of the doors. Removing the plastic is helpful but not necessary. Attach a series of adhesive Velcro strips around the roll cage. Starting from the front, the first strip should begin at the weld spot just above the bolts. The lengths are: 1) 22", 2) 24", 3) 33", 4) 12", 5) 18", 6) 6".

3. Next, place the adhesive Velcro strips along the top outside edges of the factory doors. The lengths from front to back are: 1) 6", 2) 10", 3) 9", 4) 15", 5) 20", 6) 10".

4. The following images show how this should look after all the Velcro is installed. [Visual guide showing Velcro placement on the installed doors.]

Cleaning and Storage Recommendations

1. Before removing the Cab for storage, ensure it is very clean to prevent scratching the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag. Let the Cab dry thoroughly before attempting to roll for storage.

2. It is important that the Cab be rolled up for storage rather than folding, as folding can damage the windows. Carefully roll up the Cab similarly to how it was packed at the factory. On a large, clean, and flat surface, fold the doors over the rear panel first, then interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Store the rolled Cab back into the carton at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.

3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.

Thank you for your purchase!

Return Policy

If for any reason you choose to return this product, it must be returned within 30 days from the date of receipt. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!

The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.

All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund; a 25% restocking fee will apply.

If ordered from Falcon Ridge, please call at 606-845-7439 to gain a return authorization number. Use the preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item). Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee.

If ordered from one of Falcon Ridge's many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure it is unused and in factory-new condition.

NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.

Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh and in new, resalable condition. Any returned items that have been used, altered, or damaged in any way will not be subject to a refund. All contents, including instruction manuals, accessories, hardware, Velcro, etc., must be included in your return shipment. Only items in OEM factory-new condition will be approved. Once returned items are received, credit will be issued to the original credit card/payment method used for the purchase. Outbound shipping and return shipping costs will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:

Thank you for purchasing one of Falcon Ridge's Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer's warranty.

30 Day Warranty: This warranty includes, and is not limited to, replacing the enclosure, tops, and/or windshield due to defect of the product. Please refer to the return policy in this case for more information.

1 Year Warranty: This warranty includes any defect in material or workmanship. Within this time frame, Falcon Ridge will gladly correct the problem or replace the enclosure, tops, &/or windshield. Upon submitting for the correction or replacement, we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.