FALCON RIDGE

Important Notices & Preparation

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. ⚠️

Be sure to read these instructions thoroughly before opening and installing the top cap. The installation is best done when the temperature is 70 degrees F. (21°C) or warmer. The temperature affects the adhesive Velcro; if conditions prevent installing in warmer weather, it helps to store the adhesive Velcro at room temperature prior to installation.

1. Carefully open the carton and remove the rolled-up Cab Enclosure on a large, flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.

2. Check over the parts included in the carton with the parts list shown below:

   Item	Quantity	Description
   2" Adhesive Velcro Hook	2 each	6" Long
   Webbing Straps w/ Loop	2 each	30" Long
   Webbing Straps w/ Velcro	2 each

   If any parts are damaged or missing, please contact customer service at (606) 845-7439.

3. Included in the package are two webbing straps with a loop sewn on one end. These will be used to secure the rear of the Top Cap. Wrap it around the bar just under the side safety bars as shown in the photos below.

   [Visual Description: Two webbing straps with loops are provided for securing the rear of the top cap. They are to be wrapped around the bar located just under the side safety bars.]

Installation Steps

4. Now run the looped end of one of the straps around the roll cage just under the top of the safety bar on the side. Then pull the other end of the strap through the loop and pull tight.

   [Visual Description: A strap is shown being looped around the roll cage bar just below the safety bar, with its end threaded through the loop and pulled taut.]

5. Now pull the strap up and run them through the buckles sewn into the rear corners of the Top Cap.

   [Visual Description: The strap is pulled upwards and threaded through buckles located at the rear corners of the top cap.]

6. Moving to the front of the vehicle, you will use the straps with double-sided Velcro sewn to one end. Where you attach the Velcro is up to you and can depend on whether you have a windshield installed or not. First, wrap the roll cage with the 5" adhesive Velcro strip and then wrap the double-sided Velcro around that tightly so that the strap is pointed upward towards the top cap.

7. Now run the end of the strap through the buckle as you did in the rear. Pull all straps tight, making sure the top is centered and pulled evenly on all four corners.

8. Now your enclosure should be complete. With proper care, your cab should last for years to come. Enjoy!!!

Thank you for your purchase!

Return Policy

If for any reason you choose to return this product, it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!

The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.

All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund. A 25% restocking fee will apply.

If ordered from Falcon Ridge, please call at 606-845-7439 to gain a return authorization number. Use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item). Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge's many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition.

NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.

Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered, or damaged in any way will not be subject for a refund). All contents, including instruction manuals, accessories, hardware, Velcro, etc., must be included in your return shipment. Only items in OEM factory-new condition will be approved. Once returned items are received, credit will be issued to the original credit card/payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:

Thank you for purchasing one of Falcon Ridge's Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer's warranty.

30 Day Warranty: which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information.

1 Year Warranty: includes any defect in material or workmanship within this time frame. We will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement, we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.