Gemma Medium Table Lamp
Item #: CHA 8438
Notice
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
Tools Required (Not Included)
Scissors
Assembly Steps:
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Install harp (C) by squeezing together and inserting into the top of saddle (D).
- Remove finial (A) from harp (C).
- Remove shade (B) from packaging and install to harp (C) using finial (A).
NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages.
- Install light bulb into the socket.
- Remove protective cover (E) from plug.
- Plug into electrical outlet and test the fixture.
Diagram Overview
The assembly diagram illustrates the components of the Gemma Medium Table Lamp. Key parts are labeled:
- A: Finial (used to secure the shade).
- B: Shade (packaged separately).
- C: Harp (the metal frame that supports the shade).
- D: Saddle (part of the lamp base where the harp is attached).
- E: Protective cover on the electrical plug.
The diagram shows the lamp base, stem, socket, harp, shade, and power cord with plug, indicating the sequence of assembly.
Care Instructions
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
