ASSEMBLY INSTRUCTIONS

Diagram Description

The diagram illustrates the assembly of a table lamp. Key components labeled are: (A) Finial, (B) Lamp Shade (packaged separately), (C) Harp, (D) Lamp base socket/saddle, and (E) Power plug. A light bulb is shown near the socket, with the note 'Bulb not included'.

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

Scissors

Assembly Steps

1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install harp (C) by squeezing together and inserting into the top of saddle (D).
3. Remove finial (A) from harp (C).
4. Remove shade (B) from packaging and install to harp (C) using finial (A).
5. NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages.
6. Install light bulb into the socket.
7. Remove protective cover (E) from plug.
8. Plug into electrical outlet and test the fixture.

Care Instructions

Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.