Assembly Instructions
Briar Large Floor Lamp
Item #: CHA 9591
Product Overview
This document provides assembly instructions for the Briar Large Floor Lamp by Visual Comfort, model number CHA 9591.
Diagram and Parts Identification
The lamp assembly consists of the following main parts:
- A: Finial - The decorative cap used to secure the shade to the harp.
- B: Shade - The lampshade, provided separately.
- C: Harp - The metal frame that supports the lampshade.
- D: Socket Assembly - The part where the harp connects and the light bulb is installed.
- E: Power Plug - The electrical plug with a protective cover.
Important Notice
This light fixture must be installed in accordance with all applicable local installation codes by a person familiar with its construction and operation, and aware of the associated hazards. Inspect the item and its contents thoroughly. Do not install if any damage or defect is found. Keep all packaging materials until installation is fully complete and approved.
Tools Required (Not Included)
Scissors
Assembly Steps
- Carefully remove all parts from the box and place them on a clean, soft surface.
- Install the harp (C) by squeezing its ends together and inserting the top into the saddle (D).
- Remove the finial (A) from the harp (C).
- Place the shade (B) onto the harp (C) and secure it using the finial (A).
- Note: If the shade has additional protective packaging, carefully cut it from the interior of the shade to avoid damage.
- Install a light bulb into the socket.
- Remove the protective cover (E) from the power plug.
- Plug the lamp into an electrical outlet and test its operation.
Care Instructions
Clean the lamp using only a soft, dry cloth or a feather duster. Avoid using abrasive materials or chemical cleaning agents.
