Assembly Instructions
Lamu Large Table Lamp
Item # CD 3612
Notice
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
Tools Required (Not Included)
Scissors
Assembly Steps
The diagram illustrates the components of the Lamu Large Table Lamp:
- A: Finial
- B: Lampshade (Packaged separately)
- C: Indicates that a bulb is not included.
- D: Socket ring
- E: Socket
- F: Electrical plug with a protective cover
The lamp base is also shown.
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove socket ring (D) from socket (E).
- Install harp (C) to socket (E) and secure with socket ring (D).
- Remove finial (A) from harp (C).
- Remove shade (B) from packaging and install to harp (C) using finial (A).
NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages.
- Install light bulb into the socket.
- Remove protective cover (F) from plug.
- Plug into electrical outlet and test the fixture.
Care Instructions
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
