Tow-Trust Towbars
Important: Please read General Notes overleaf before fitting
Issue 4
TV354 VAUXHALL VECTRA EST 2003 - 2009
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | G | 2 | M16 x 50 Bolts, Nuts & S/P Washers |
| B | 1 | L/H Side Arm | J | 6 | M12 x 170 Bolts, Nuts & S/P Washers |
| C | 1 | R/H Side Arm | K | 4 | M12 x 40 Bolts, 2 Nuts & 4 S/P Washers |
| D | 6 | Clamp Plates | L | 12 | 12 x 25 Flat Washers |
| E | 4 | 19 x 119 Spacer Tubes | |||
| F | 2 | 19 x 136 Spacer Tubes |
Installation Instructions
- Remove luggage tie down hooks from each corner of the boot. Temporarily remove the central cover and remove torx head screw. Remove the two screws on the inside face securing the rear panel. Locate the screw behind the plastic trim and loosen both boot side trims.
- Locate the three dimples above each chassis member inside the boot and drill out top skin only to 20mm.
- Place Item E down through the two forward holes and Item F into the rear hole each side.
- Place Item D over each spacer tube inside the boot and pass Item J down through each tube.
- Loosely bolt Item B and Item C to the bottom face of each chassis using the nuts and washers (Item L) provided.
- Using Item K with Item L bolt Item A to Item B and Item C.
- Using Item G bolt the ball bracket and wiring plate (not supplied with this kit) to the mounting plate.
- Fully tighten all nuts and bolts and ensure the towbar is rigid and secure.
- Replace all trim.
Diagram Description: The diagram illustrates the towbar assembly components and their connection points. It shows the main crossmember (A) connecting to the left-hand (B) and right-hand (C) side arms. Spacer tubes (E, F) are shown being inserted into vehicle chassis holes, secured by bolts (J) and clamp plates (D). The assembly is fastened using various bolts and washers (G, K, L). The visual representation indicates how these parts integrate with the vehicle's chassis for a secure towbar fitting.
Note: Nose load limits and vehicle manufacturers' trailer/caravan weight limits must be observed.
