HAMNSKÄR Wash-Basin Mixer Tap
IKEA Design and Quality
Contents
Tools and spare parts
Illustration of product, parts and part numbers
Product assembly
Important Installation Notes
ⓘ Installation shall be carried out in accordance with Industry Regulations Säker Vatteninstallation.
⚠ Switch off main shut-off valve before changing mixer tap.
Certifications: KIWA, EN 817, EN 1717.
RSK No: 8275784.
Preparation and Specifications
For installation assistance and further details, visit www.IKEA.com.
Required Tools: Wrench (2x).
Operating Conditions:
- Recommended Operating Temperature: Max. 60°C
- Maximum Operating Temperature: Max. 80°C
- Recommended Operating Pressure: 1-5 bar
- Maximum Operating Pressure: 0.5-10 bar
Pipe Connection: G3/8" (R10)
Parts List
The following parts are included:
- 2x Part 121844
- 1x Part 121845
- 1x Part 121846
- 2x Part 10093113
- 1x Part 126907
Assembly Steps
Step 1: Mounting the Mixer Tap
Seal the open surfaces with silicone to prevent water from penetrating the worktop upon any leaks. Silicone is not included.
The silicone sealant must be water- and mould-resistant and suitable for the installation, according to EN 15651-3, Class XS1.
Ensure the worktop hole diameter is between Ø 34 - 37 mm (Ø 1 3/8" - 1 7/16").
[Diagram: Person applying sealant to the base of the mixer tap before mounting it to the worktop.]Step 2: Connecting Water Hoses
[Diagram: Water hoses being connected to the mixer tap body and the water supply lines.]The pipe connection needs to be flat and free from sharp edges.
Step 3: Tightening Connections
Use wrenches to tighten the connections securely. Ensure connections are snug but do not overtighten, as this can damage hoses/pipes and washers.
[Diagram: Wrenches being used to tighten the water hose connections.]Step 4: Final Checks and Flushing
Before use, unscrew the Aerator/Flow Guide and allow the water to run freely for a few minutes to flush out any debris. Then screw the Aerator/Flow Guide back in place. Ensure it is tight to prevent removal by hand.
[Diagram: Sequence showing the aerator being unscrewed, water flushing through the tap, and the aerator being screwed back in.]Check at regular intervals to make sure that the installation is not leaking.
Exploded View and Part Identification
The HAMNSKÄR mixer tap consists of the following main components:
- Handle assembly (Part 10092255)
- Cartridge (Part 10095595)
- Aerator/Flow Guide (Part 10091769)
- Part (Part 10004087)
- Mixer body (Part 126907)
- Pipe connection (G3/8" / R10)
- Mounting bracket (Part 121844)
- Hose (Part 10093113)
- Mounting bracket (Part 121845)
- Mounting bracket (Part 121846)
