Scosche LS2081 In-Dash Installation Kit
For 1997-01 Lexus ES300 Vehicles
Pocket Assembly
Insert the pocket through the front of the panel and snap into place.
[Diagram: Shows a car stereo pocket and mounting brackets.]
Single DIN Assembly
[Diagram: Shows a car stereo mounting bracket, a pocket/housing, and side trim pieces for a single-DIN stereo.]
Stereo Installation
Disassembly Instructions:
- Using panel removal tool, unsnap small trim piece between ashtray and bottom of A/C control.
- Unsnap A/C vent/clock assembly above radio and remove.
- Extract (4) Philips head screws securing radio and climate control. Disconnect and remove.
- Extract (4) Philips head screws securing climate control to factory brackets.
Double DIN Assembly
[Diagram: Shows a car stereo mounting bracket, a pocket/housing, and side trim pieces for a double-DIN stereo.]
Introduction / Preliminary
Thank you for purchasing the Scosche LS2083 Kit. This kit was manufactured with the highest of quality standards.
Caution:
Disconnect your vehicle's negative battery terminal before the installation to help prevent electrical damage. We recommend the use of a volt/ohm meter over a test light to check wiring. A test light or grounded wire probe can cause damage to the vehicle's computer and/or diagnostic systems. Avoid all factory air bag wiring - air bags can accidentally deploy causing serious injury or death.
Notes:
- See your vehicle's instructions for any special tools your installation might require.
- Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting instructions.
Factory Wiring Codes
| CAR STEREO CONNECTORS | TA02 | TA03 |
|---|---|---|
| Provide easy connection of your car stereo to factory wiring harness. | TA02 1987-UP Toyota Non-Amplified |
TA03 2000-UP Toyota Amplified (Non-JBL) |
[Diagram TA02: Shows a wiring harness connector for 1987-UP Toyota Non-Amplified vehicles.]
[Diagram TA03: Shows a wiring harness connector for 2000-UP Toyota Amplified (Non-JBL) vehicles.]
Liability Disclaimer
This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/codes and information pertaining to installation of this kit (LS2081) in 1997-01 Lexus ES300 Vehicles. Scosche Industries, Inc. can not be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or options, or damage that may occur in the automobile during the installation of components while using this booklet.
