Contact Information
USA office: Fontana
ITA office: Milano
AUS office: Truganina
POL office: Gdańsk
DEU office: FDS GmbH, Neuer Höltigbaum 36, 22143 Hamburg, Deutschland
GBR office: FDS Corporation Limited, Unit 4, Blackacre Road, Great Blakenham, Ipswich, Ip6 0FL, United Kingdom
FRA office: Saint Vigor d'Ymonville
For assistance, please contact our customer service:
USA: cs.us@costway.com
AUS: cs.au@costway.com
GBR: cs.uk@costway.com
ITA: cs.it@costway.com
POL: sklep@costway.com
DEU: cs.de@costway.com
FRA: cs.fr@costway.com
ESP: cs.es@costway.com
Before You Start
Please read all instructions carefully and keep for future reference.
General Security Warning
Caution: Children should use this product under the parental supervision.
Danger: Keep all small parts and packaging materials for this product away from babies and children, otherwise they may pose a choking hazard.
Danger: Lack of attachment may cause a risk of tipping.
WARNING: CHOKING HAZARD - Small parts and small ball. Not for children under 3 years.
WARNING FOR ASSEMBLY
- Assembled only by adults
- Remove all packaging, separate and count all parts and hardware.
- Read through each step carefully and follow the proper order.
- We recommend that, where possible, all items are assembled near the area in which they will be placed in use, to avoid moving the product unnecessarily once assembled.
- Ensure a secure surface during installation, and always place the product on a flat, steady and stable surface.
WARNING: Adult Assembly Required.
Tools Required
Standard (Flat Head Screwdriver) - Not Included
Allen Key - Included
High Torque: Over Tightened
Recommended
Electric Screwdrivers may be helpful during assembly; however, please set a low torque and use with extreme caution.
Important Notice!
- This product is intended for INDOOR use only.
- Please do not sit, climb or lean on the product.
- Please do not drag the product when moving it in order to avoid damaging the legs.
- Please only use spray furniture polish to clean the exterior surfaces of the product.
- This is not a child's toy, adult supervision is required when children are playing this game.
Applicable age: 6+
Parts Identifier
- 1 Side Apron (x2)
- 2 End Apron (x2)
- 3 Right Leg (x2)
- 4 Left Leg (x2)
- 5 Play-field (x1)
- 6 Support Brace (x2)
- 7 End Leg Panel (x2)
- 8 Slide Scorer (x2)
- 9 Leg Leveler (x4)
- 10 Foam Bumper (x12)
- 11 Handle (x6)
- 12 Rod End Cap (x6)
- 13 3-Hole Rod (x6)
- 14 Player - Red (x9)
- 15 Player - Blue (x9)
- 16 Goal Box - Top (x2)
- 17 Goal Box - Bottom (x2)
Accessories
- 18 Soccer Ball (x2)
Hardware
- A1 3.5x35mm Screw (x4)
- A2 3.5x35mm Flat Head Screw (x2)
- A3 1/4" Washer (x8)
- A4 1/4"x1" Bolt (x16)
- A5 3.5x18mm Screw (x22)
- A6 3.5x12mm Screw (x16)
- A7 Allen Key (x1)
Assembly Instructions
Before Assembly
- Find a clean, level place to begin the assembly of your product.
- Verify that you have all listed parts as shown on the part list pages. If any parts are missing, call our customer service.
Assembly
FIG. 1
Note: Do NOT tighten Screws (A2) until FIG. 3.
FIG. 2
Note: The play-field surface should face down when assembling.
FIG. 3
After this step, tighten screws.
FIG. 4
Assembly step illustration showing attachment of parts.
FIG. 5
Assembly step illustration showing attachment of parts.
FIG. 6
Assembly step illustration showing attachment of parts.
FIG. 7
Note: Go back and make sure that all connections are tightened.
CAUTION
Two strong adults are recommended to turn over the table as shown.
- Lift the table off the ground.
- Turn the table over.
- Place it on all four feet at the same time on the ground.
FIG. 8
Note: The Rods have a hole at the end where their Handles will go.
Note: Players of the same team color should have Handles on the same side, and each team's players should be facing their opponent.
FIG. 9
Assembly step illustration showing attachment of parts.
FIG. 10
Assembly step illustration showing attachment of parts.
YOU ARE NOW READY TO PLAY!
Return / Damage Claim Instructions
- DO NOT discard the box / original packaging. In case a return is required, the item must be returned in original box. Without this your return will not be accepted.
- Take a photo of the box markings. A photo of the markings (text) on the side of the box is required in case a part is needed for replacement. This helps our staff identify your product number to ensure you receive the correct parts.
- Take a photo of the damaged part (if applicable). A photo of the damage is always required to file a claim and get your replacement or refund processed quickly. Please make sure you have the box even if it is damaged.
- Send us an email with the images requested. Email us directly from marketplace where your item was purchased with the attached images and a description of your claim.
