Falcon Ridge

Important Notice

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. ?

Installation Instructions

1. Be sure to read these instructions thoroughly before opening and installing the Yamaha Wolverine Soft Rear Window. The installation is best done when the temperature is 70 degrees F. (approx. 21°C) or warmer. The temperature affects the adhesive Velcro; if conditions prevent installing in warmer weather, it helps to store the adhesive Velcro at room temperature prior to installation.

2. Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.

3. Check over the parts included in the carton with the parts list shown below:

   Part	Quantity	Length
   Adhesive Velcro Hook Strips	2 each	9"
   Adhesive Velcro Hook Strips	1 each	15"
   Adhesive Velcro Hook Strips	2 each	40"
   Rear Window	1	N/A

4. Begin by taking one of the 40" adhesive Velcro strips and run it up the back of the roll cage, facing towards the rear of the vehicle. You will see three double-sided Velcro tabs sewn along the back of the doors. Begin installing the adhesive Velcro from the bottom of the roll cage and work your way up the bar. See diagram below.

5. Begin attaching the Rear Window by connecting the Velcro down the sides to the adhesive Velcro. Starting at the bottom on one side, work your way to the top, then pull it across and do the same on the other side. Make sure that the Rear Window is centered and pulled tight from side to side.

6. Then place the two 9" and one of the 15" adhesive Velcro strips across the top of the roll cage. Make sure to place them on top of the bar. The image below shows how it should look.

Cleaning and Storage Recommendations

1. Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage. ?

2. It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean, and flat surface, fold the doors over the rear panel first, then interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing. ?

3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered. ?

Return Policy

If for any reason you choose to return this product, it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!

The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.

All returned products will be inspected upon arrival at the production facility and must be in unused, factory new condition to receive a refund. A 25% restocking fee will apply.

If ordered from Falcon Ridge, please call at 606-845-7439 to gain a return authorization number. Use our preferred shipping carrier (UPS) to return the item (unless the item is defective, in which case you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee.

If ordered from one of Falcon Ridge's many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.

NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.

Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh and in new resalable condition (any returned items that have been used, altered, or damaged in any way will not be subject to a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved.

Once returned items are received, credit will be issued to the original credit card/payment method used for the purchase. Outbound shipping and return shipping costs will not be refunded. Please allow 4 to 6 weeks for your refund to be processed. ⏳

Warranty

To The Owner of this Product:

Thank you for purchasing one of Falcon Ridge's Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer's warranty.

30 Day Warranty: This includes, but is not limited to, replacing the enclosure, tops, and/or windshield due to a defect of the product. Please refer to the return policy for more information.

1 Year Warranty: This includes any defect in material or workmanship within this time frame. We will gladly correct the problem or replace the enclosure, tops, &/or windshield. Upon submitting for the correction or replacement, we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase. ?️

Thank you,
Falcon Ridge