Recon Chat for PS4 Headset

TurtleBeach Recon Chat for PS4 Headset

instruction Guide

FASCICULUS INDEX RERUM

  1. Recon Chat Headband (A)
  2. Recon Chat Earcup with Microphone (B)

FASCICULUS INDEX RERUM

ASSEMBLE THE RECON CHAT

ASSEMBLE THE RECON CHAT

IN-LINE CONTROLS

IN-LINE CONTROLS

  1. SWITCH PB Mi muta
    • Switch admute_button_black.png to mute the microphone.
  2. Magister Volubilis
    • Adjust the master volume of the incoming chat audio.

PS4 ERECTUS

PS4 ERECTUS

  1. Go to Settings >> Devices >> Audio Devices.
      • set initus & output Corporis Fabrica ut Headset Connected to Controller.
      • set Ut output Music ut Chat Audio.
      • set Volume Control (Headphones) level to Maximum.
  2. select Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.

Xbox Alter ERECTUS

Nota: The Recon Chat works with Xbox One Controllers with a 3.5mm headset jack. Other controllers require the Xbox One Headset Audio Controller.

1. Plug the headset into the Xbox controller.

Xbox Alter ERECTUS

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

3. Configure your settings as shown:

  • set Headset Volume ut maximum
  • set Mic Monitor ut vestra preferred aequum

Headset Volume


Xbox Setup

To set your Recon Chat For PS4 up for use with an Xbox console, please do the following. Please note this information applies to both the Xbox One and Xbox Series X|S consoles.

1. Plug the headset into the Xbox controller.

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

Xbox moderatoris

3. Configure your settings as shown*:

  • set Headset Volume ut maximum
  • set Mic Monitor ut potius aequum

*The Headset Chat Mixer option will be greyed out; this headset will play chat audio only, so this setting is not needed for this particular headset.

configure

WINDOWS SONIC SURROUND SOUND

1. While in the Home screen, press the Xbox button on the controller. You’ll see the following screen:

WINDOWS SONIC

2. Navigo ut quiafile & System Tab, and select “occasus".

quiafile & System

3. ad General >> Volume & Audio Output

Volume & Audio Output

4. In Genius | Audio column (right side of the screen), set Headset Format ut Mors enim Fenestra Music.

Genius | Audio


Sed sapien PRAEFIXUS

This article details the best way to set your Recon Chat for PS4 headset up for use with a PS4 or PS5 consolationi faciles.

PS4 ERECTUS

If you have a PS4/PS4 Pro console, please do the following.

PS4 ERECTUS

  1. Go to Settings >> Devices >> Audio Devices.
      • set initus & output Corporis Fabrica ut Headset Connected to Controller.
      • set Ut output Music ut Chat Audio.
      • set Volume Control (Headphones) level to Maximum.
  2. select Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.
PS5 ERECTUS

If you instead have a PS5 console, please do the following.

  1. Plug the headset into the aux port in the DualSense controller. Once you do this, the microphone function will automatically switch from the controller’s integrated mic to your headset.
  2. Go to Settings >> Sound >> Audio Output >> Output Device
      • select Headset Connected To Controller quia INVENTUM output
      • Set Output to Headphones to Chat Audio
  3. Go to Settings >> Sound >> Volume >> Headphones
      • set Volume Control (headphones) campester to maximum
  4. Adjust your microphone levels by going to Settings >> Sound >> Microphone >> Adjust Mic Level >> Microphone Level

Regulatory Compliance Statements for the EAR FORCE Reran Chat Model

Federal Communicationibus Commissionis (& c) Obsequium III

Class El Interference Statement

This equipment has been tested and found to comply with the Limits for a Class B digital device, pursuant to Part 15, Subpart B of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference M a residential installation. This equipment generates. uses. and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Aut antenna, accipiendo relocate ad reorient.
  • Proventus differentias noveritis mundi et apparatu et acceperit existimare possis.
  • Committere exitum in circuitu vasa in alio recipitur cui coniungitur.
  • Vel furente consulam peritus radio / TV TECHNICUS auxilium.

Cautus esto FCC.

Haec machina cum Parte XV de Regulis FCC obtemperat. Operatio subest duabus condicionibus sequentibus: 15. Id machinamentum nocivum impedire non potest, et 1. haec machina quaelibet impedimenta accepta debet accipere, etiam impedimentum quod operatio necopinata causare potest.

Canadian ICES Dictiones

Canadian Department of Communications Radio Interference Regulations This digital apparatus does not exceed the Class B limits for radio-noise emissions from a digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. NMB-003 du Canada.

European Union and European Fair Trade Association (EFTA) Regulatory Compliance Declaration of Conformity Marking by this symbol:

CE indicates compliance with the Essential Requirements of the EMC Directive of the European Union 12014/30/EU). This equipment meets the following conformance standards:

salutem: EN 60950-1: 2006 +A11: 2009 + Al: 2010 +Al2: 2011 + A2: 2014 IT-Mark License), IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013 (CB Scheme Certificate), EN 50332-1: 2000, EN 50332-2: 2003, EN 71-3: 2013 ALso Licensed for Standards: UL 60950-1: 2007 R10.14, CAN/CSA-C22.2 No.60950-1-07 +41: 2011 + A2: 2014 Additional licenses issued for specific countries available on request

emissiones: EN 55022: 2010 + AC: 2011, CISPR 22: 2008

Immunitatem: EN 55024: 2010, CISPR 24: 2010, EN 61000-4-2: 2009, EN 61000-4-3: 2006 .A2: 2010, EN 61000-4-8: 2010

The products are Licensed, as required, for additional country specific standards for the International Marketplace. Additional issued licenses available upon request.

environmental: Low Voltage Directive 2014/35/EU, RoHS 2011/65/EU. REACH 2006/1907/EC, WEEE 2012/19/EU. Packaging 94/62/EC. Toys Safety Directive 2009/48/EC

arbitrioHoc productum adpensum quid ob recordationem, aut productum packaging indicat quod aliud est non omnino tamen residente cum familia vastum. Instead, id est, curae vestrae censetis animum tuum vastum apparatu a iurisdictione tradita est collectio ad certum punctum ad redivivus de vastum et electrica apparatu electronic. Collectionem et singula vasa redivivus tempore praesto erit deserta conservant videat quod naturae humanae salutis protegentis REDIVIVUS quodammodo elit. Pro magis notitia in qua vos can stillabunt de pedibus tuis locus redivivus vastum in placet liberum contactus tuum loci auctoritate, aut quo pretio tuum opus.

Placere visitare haec URL in integrum exemplum memoravit Declaratio conformitatis;

http://www.turtlebeach.com/homologation  
This product is compliant with the Consumer Product Safety Improvement Act of 2008. Public Law 110-314 (CPSIA)


Download

TurtleBeach Recon Chat for PS4 Headset Instruction Guide – [ Download PDF ]


 

Leave a comment

Curabitur sit amet nisl.