Recon Chat for PS4 Headset

TurtleBeach Recon Chat for PS4 Headset

Ynstruksjegids

PAKKETINNE

  1. Recon Chat Headband (IN)
  2. Recon Chat Earcup with Microphone (B)

PAKKETINNE

ASSEMBLE THE RECON CHAT

ASSEMBLE THE RECON CHAT

IN-LINE CONTROLS

IN-LINE CONTROLS

  1. Mic Mute Switch
    • Oerskeakelje neimute_button_black.png to mute the microphone.
  2. Master Volume
    • Adjust the master volume of the incoming chat audio.

PS4 SETUP

PS4 SETUP

  1. gean nei Settings >> Devices >> Audio Devices.
      • set Ynfier & Utfierapparaten nei Headset Connected to Controller.
      • set Utfier nei koptelefoan nei Chat Audio.
      • set Volume Control (koptelefoan) level to Maximum.
  2. Útkieze Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.

XBOX ONE SETUP

Noat: The Recon Chat works with Xbox One Controllers with a 3.5mm headset jack. Other controllers require the Xbox One Headset Audio Controller.

1. Plug the headset into the Xbox controller.

XBOX ONE SETUP

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

3. Configure your settings as shown:

  • set Headset Volume nei Maksimum
  • set Mic Monitor nei dyn Kontakt peil

Headset Volume


Xbox ynstelle

To set your Recon Chat For PS4 up for use with an Xbox console, please do the following. Please note this information applies to both the Xbox One and Xbox Series X|S consoles.

1. Plug the headset into the Xbox controller.

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

Xbox -controller

3. Configure your settings as shown*:

  • set Headset Volume nei Maksimum
  • set Mic Monitor nei preferred peil

*The Headset Chat Mixer option will be greyed out; this headset will play chat audio only, so this setting is not needed for this particular headset.

ynstelle

WINDOWS SONIC SURROUND SOUND

1. While in the Home screen, press the Xbox button on the controller. You’ll see the following screen:

WINDOWS SONIC

2. Gean nei de perfile & System Tab, and select “ynstellings".

perfile & System

3. Gean nei General >> Volume & Audio Output

Volume & Audio Output

4. Yn de Headset Audio column (right side of the screen), set Headset Format nei Windows Sonic Foar koptelefoan.

Headset Audio


PlayStation Setup

This article details the best way to set your Recon Chat for PS4 headset up for use with a PS4 or PS5 konsole.

PS4 SETUP

If you have a PS4/PS4 Pro console, please do the following.

PS4 SETUP

  1. gean nei Settings >> Devices >> Audio Devices.
      • set Ynfier & Utfierapparaten nei Headset Connected to Controller.
      • set Utfier nei koptelefoan nei Chat Audio.
      • set Volume Control (koptelefoan) level to Maximum.
  2. Útkieze Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.
PS5 SETUP

If you instead have a PS5 console, please do the following.

  1. Plug the headset into the aux port in the DualSense controller. Once you do this, the microphone function will automatically switch from the controller’s integrated mic to your headset.
  2. gean nei Settings >> Sound >> Audio Output >> Output Device
      • Útkieze Headset Connected To Controller foar Utfierapparaat
      • Set Output to Headphones to Chat Audio
  3. gean nei Settings >> Sound >> Volume >> Headphones
      • set Volume Control (headphones) nivo oan Maksimum
  4. Adjust your microphone levels by going to Settings >> Sound >> Microphone >> Adjust Mic Level >> Microphone Level

Regulatory Compliance Statements for the EAR FORCE Reran Chat Model

Notysjes foar neilibjen fan 'e Federal Communications Commission (FCC)

Class El Interference Statement

This equipment has been tested and found to comply with the Limits for a Class B digital device, pursuant to Part 15, Subpart B of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference M a residential installation. This equipment generates. uses. and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • De orizjinele antenne opnij oriïntearje of ferpleatse.
  • Fergrutsje de skieding tusken de apparatuer en ûntfanger.
  • Ferbine de apparatuer yn in stopkontakt op in circuit oars as dat wêrop de ûntfanger is ferbûn.
  • Rieplachtsje de dealer as in erfarne radio / tv-technikus foar help.

FCC Foarsichtigens.

Dit apparaat foldocht oan diel 15 fan 'e FCC -regels. Operaasje is ûnderwurpen oan de folgjende twa betingsten: 1. Dit apparaat kin gjin skealike ynterferinsje feroarsaakje, en 2. dit apparaat moat alle ûntfongen ynterferinsjes akseptearje, ynklusyf ynterferinsje dy't kin feroarsaakje net winske operaasje.

Kanadeeske ICES-ferklearrings

Canadian Department of Communications Radio Interference Regulations This digital apparatus does not exceed the Class B limits for radio-noise emissions from a digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. NMB-003 du Canada.

European Union and European Fair Trade Association (EFTA) Regulatory Compliance Declaration of Conformity Marking by this symbol:

CE indicates compliance with the Essential Requirements of the EMC Directive of the European Union 12014/30/EU). This equipment meets the following conformance standards:

Feilichheid: EN 60950-1: 2006 +A11: 2009 + Al: 2010 +Al2: 2011 + A2: 2014 IT-Mark License), IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013 (CB Scheme Certificate), EN 50332-1: 2000, EN 50332-2: 2003, EN 71-3: 2013 ALso Licensed for Standards: UL 60950-1: 2007 R10.14, CAN/CSA-C22.2 No.60950-1-07 +41: 2011 + A2: 2014 Additional licenses issued for specific countries available on request

Utstjit: EN 55022: 2010 + AC: 2011, CISPR 22: 2008

immuniteit: EN 55024: 2010, CISPR 24: 2010, EN 61000-4-2: 2009, EN 61000-4-3: 2006 .A2: 2010, EN 61000-4-8: 2010

The products are Licensed, as required, for additional country specific standards for the International Marketplace. Additional issued licenses available upon request.

Miljeu: Low Voltage Directive 2014/35/EU, RoHS 2011/65/EU. REACH 2006/1907/EC, WEEE 2012/19/EU. Packaging 94/62/EC. Toys Safety Directive 2009/48/EC

FerwideringDit symboal op it produkt of de ferpakking jout oan dat dit produkt net mei jo oare húshâldlik ôffal moat wurde ôffierd. Ynstee is it jo ferantwurdlikens om jo ôffalapparatuer te ferwiderjen troch it oer te jaan oan in oantsjutte sammelpunt foar it recycling fan ôffal elektryske en elektroanyske apparatuer. De aparte samling en recycling fan jo ôffalapparatuer op it momint fan beskikking sil helpe by it behâld fan natuerlike boarnen en soargje dat it wurdt recycled op in manier dy't de sûnens en it miljeu fan minsken beskermet. Foar mear ynformaasje oer wêr't jo jo ôffal kinne ôfleverje foar recycling, kinne jo kontakt opnimme mei jo lokale autoriteit, of wêr't jo jo produkt kochten.

Besykje asjebleaft it folgjende URL foar in folsleine kopy fan 'e Ferklearring fan Konformiteit:

http://www.turtlebeach.com/homologation  
This product is compliant with the Consumer Product Safety Improvement Act of 2008. Public Law 110-314 (CPSIA)


Download

TurtleBeach Recon Chat for PS4 Headset Instruction Guide – [ Download PDF ]


 

Lit in reaksje efter

Jo e-mailadres wurdt net publisearre.