Recon Chat for PS4 Headset

TurtleBeach Recon Chat for PS4 Headset

Guía de instrucións

CONTIDOS DE PAQUETE

  1. Recon Chat Headband (A)
  2. Recon Chat Earcup with Microphone (B)

CONTIDOS DE PAQUETE

ASSEMBLE THE RECON CHAT

ASSEMBLE THE RECON CHAT

IN-LINE CONTROLS

IN-LINE CONTROLS

  1. Interruptor de silencio de micrófono
    • Cambiar amute_button_black.png to mute the microphone.
  2. Volume Mestre
    • Adjust the master volume of the incoming chat audio.

CONFIGURACIÓN PS4

CONFIGURACIÓN PS4

  1. Ir a Settings >> Devices >> Audio Devices.
      • Conxunto Entrada & Dispositivos de saída a Headset Connected to Controller.
      • Conxunto Saída a auriculares a Chat Audio.
      • Conxunto Control de volume (auriculares) level to Maximum.
  2. seleccionar Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.

CONFIGURACIÓN DE XBOX ONE

Nota: The Recon Chat works with Xbox One Controllers with a 3.5mm headset jack. Other controllers require the Xbox One Headset Audio Controller.

1. Plug the headset into the Xbox controller.

CONFIGURACIÓN DE XBOX ONE

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

3. Configure your settings as shown:

  • Conxunto Volume dos auriculares a máximo
  • Conxunto Mic Monitor a súa preferido nivel

Volume dos auriculares


Configuración de Xbox

To set your Recon Chat For PS4 up for use with an Xbox console, please do the following. Please note this information applies to both the Xbox One and Xbox Series X|S consoles.

1. Plug the headset into the Xbox controller.

2. While in the Home screen, press the Xbox button on the controller. Scroll down to the buttons on the bottom of the left sidebar, and then select the Speaker icon (Audio).

Controlador Xbox

3. Configure your settings as shown*:

  • Conxunto Volume dos auriculares a máximo
  • Conxunto Mic Monitor a preferido nivel

*The Headset Chat Mixer option will be greyed out; this headset will play chat audio only, so this setting is not needed for this particular headset.

Configurar

WINDOWS SONIC SURROUND SOUND

1. While in the Home screen, press the Xbox button on the controller. You’ll see the following screen:

WINDOWS SONIC

2. Desprácese ata a porfile & System Tab, and select “Configuración".

porfile & System

3. Ir a General >> Volume & Audio Output

Volume & Audio Output

4. No Audio de auriculares column (right side of the screen), set Headset Format a Windows Sonic para auriculares.

Audio de auriculares


Configuración de PlayStation

This article details the best way to set your Recon Chat for PS4 headset up for use with a PS4 or PS5 consola.

CONFIGURACIÓN PS4

If you have a PS4/PS4 Pro console, please do the following.

CONFIGURACIÓN PS4

  1. Ir a Settings >> Devices >> Audio Devices.
      • Conxunto Entrada & Dispositivos de saída a Headset Connected to Controller.
      • Conxunto Saída a auriculares a Chat Audio.
      • Conxunto Control de volume (auriculares) level to Maximum.
  2. seleccionar Adjust Microphone Level and follow the on-screen instructions to calibrate your microphone.
CONFIGURACIÓN PS5

If you instead have a PS5 console, please do the following.

  1. Plug the headset into the aux port in the DualSense controller. Once you do this, the microphone function will automatically switch from the controller’s integrated mic to your headset.
  2. Ir a Settings >> Sound >> Audio Output >> Output Device
      • seleccionar Headset Connected To Controller para Dispositivo de saída
      • Set Output to Headphones to Chat Audio
  3. Ir a Settings >> Sound >> Volume >> Headphones
      • Conxunto Volume Control (headphones) nivel a máximo
  4. Adjust your microphone levels by going to Settings >> Sound >> Microphone >> Adjust Mic Level >> Microphone Level

Regulatory Compliance Statements for the EAR FORCE Reran Chat Model

Avisos de cumprimento da Comisión Federal de Comunicacións (FCC)

Class El Interference Statement

This equipment has been tested and found to comply with the Limits for a Class B digital device, pursuant to Part 15, Subpart B of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference M a residential installation. This equipment generates. uses. and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorientar ou recolocar a antena receptora.
  • Aumenta a separación entre o equipo e o receptor.
  • Conecte o equipo a unha toma dun circuíto diferente ao que está conectado o receptor.
  • Consulte co distribuidor ou cun técnico de radio / TV experimentado para obter axuda.

FCC Precaución.

Este dispositivo cumpre coa Parte 15 das normas da FCC. O funcionamento está suxeito ás dúas condicións seguintes: 1. Este dispositivo non pode causar interferencias prexudiciais e 2. este dispositivo debe aceptar calquera interferencia recibida, incluídas as que poidan causar un funcionamento non desexado.

Declaracións ICES canadenses

Canadian Department of Communications Radio Interference Regulations This digital apparatus does not exceed the Class B limits for radio-noise emissions from a digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. NMB-003 du Canada.

European Union and European Fair Trade Association (EFTA) Regulatory Compliance Declaration of Conformity Marking by this symbol:

CE indicates compliance with the Essential Requirements of the EMC Directive of the European Union 12014/30/EU). This equipment meets the following conformance standards:

Seguridade: EN 60950-1: 2006 +A11: 2009 + Al: 2010 +Al2: 2011 + A2: 2014 IT-Mark License), IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013 (CB Scheme Certificate), EN 50332-1: 2000, EN 50332-2: 2003, EN 71-3: 2013 ALso Licensed for Standards: UL 60950-1: 2007 R10.14, CAN/CSA-C22.2 No.60950-1-07 +41: 2011 + A2: 2014 Additional licenses issued for specific countries available on request

Emisións: EN 55022: 2010 + AC: 2011, CISPR 22: 2008

inmunidade: EN 55024: 2010, CISPR 24: 2010, EN 61000-4-2: 2009, EN 61000-4-3: 2006 .A2: 2010, EN 61000-4-8: 2010

The products are Licensed, as required, for additional country specific standards for the International Marketplace. Additional issued licenses available upon request.

Ambiental: Baixo Voltage Directive 2014/35/EU, RoHS 2011/65/EU. REACH 2006/1907/EC, WEEE 2012/19/EU. Packaging 94/62/EC. Toys Safety Directive 2009/48/EC

DisposiciónEste símbolo do produto ou o seu envase indica que este non se debe desbotar cos seus outros residuos domésticos. Pola contra, é a súa responsabilidade eliminar os seus residuos entregándoos a un punto de recollida designado para a reciclaxe de residuos de equipos eléctricos e electrónicos. A recollida e reciclaxe por separado dos seus residuos no momento da súa eliminación axudará a conservar os recursos naturais e garantir que se reciclarán de xeito que protexa a saúde humana e o medio ambiente. Para obter máis información sobre onde pode deixar os seus residuos para reciclar, contacte coa súa autoridade local ou onde comprou o seu produto.

Visita o seguinte URL para obter unha copia completa da Declaración de conformidade:

http://www.turtlebeach.com/homologation  
This product is compliant with the Consumer Product Safety Improvement Act of 2008. Public Law 110-314 (CPSIA)


descargar

TurtleBeach Recon Chat for PS4 Headset Instruction Guide – [ descargar PDF ]


 

Deixe un comentario

Enderezo de correo electrónico non será publicado.